Search results
Results from the WOW.Com Content Network
4-channel stereo multiplexed analog-to-digital converter WM8775SEDS made by Wolfson Microelectronics placed on an X-Fi Fatal1ty Pro sound card AD570 8-bit successive-approximation analog-to-digital converter AD570/AD571 silicon die INTERSIL ICL7107. 3.5 digit (i.e. conversion from analog to a numeric range of 0 to 1999 vs. 3 digit range of 0 to 999, typically used in meters, counters, etc ...
A 1953 paper "Coding by Feedback Methods" [1] describes "decoding networks" that convert numbers (in any base) represented by voltage sources or current sources connected to resistor networks in a "shunt resistor decoding network" (which in base 2 corresponds to the binary-weighted configuration) or in a "ladder resistor decoding network" (which in base 2 corresponds to R–2R configuration ...
The decibel originates from methods used to quantify signal loss in telegraph and telephone circuits. Until the mid-1920s, the unit for loss was miles of standard cable (MSC). 1 MSC corresponded to the loss of power over one mile (approximately 1.6 km) of standard telephone cable at a frequency of 5000 radians per second (795.8 Hz), and matched closely the smallest attenuation detectable to a ...
Similarly, one can use a multiple of the basic measurement unit: 8.0 km is equivalent to 8.0 × 10 3 m. It indicates a margin of 0.05 km (50 m). However, reliance on this convention can lead to false precision errors when accepting data from sources that do not obey it. For example, a source reporting a number like 153,753 with precision ...
ASCII reserves the first 32 code points (numbers 0–31 decimal) and the last one (number 127 decimal) for control characters. These are codes intended to control peripheral devices (such as printers ), or to provide meta-information about data streams, such as those stored on magnetic tape.
If one looks at red numbers on the chart specifying grade, one can see the quirkiness of using the grade to specify slope; the numbers go from 0 for flat, to 100% at 45 degrees, to infinity as it approaches vertical. Slope may still be expressed when the horizontal run is not known: the rise can be divided by the hypotenuse (the slope length).
contains 6% aluminium, 4% vanadium and 0.04% to 0.08% palladium. Grade 25 contains 6% aluminium, 4% vanadium and 0.3% to 0.8% nickel and 0.04% to 0.08% palladium. Grades 26, 26H, and 27 A hexagon formed from thermal stir welding of a Titanium alloy all contain 0.08 to 0.14% ruthenium. Grade 28
The neutral value of the pH depends on the temperature and is lower than 7 if the temperature increases above 25 °C. The pH range is commonly given as zero to 14, but a pH value can be less than 0 for very concentrated strong acids or greater than 14 for very concentrated strong bases. [2]