Search results
Results from the WOW.Com Content Network
SMPTE has also adopted AFD for baseband SDI carriage as standard SMPTE 2016-1-2007, "Format for Active Format Description and Bar Data". Active Format Description is occasionally incorrectly referred to as "Active Format Descriptor". There is no "descriptor" (descriptor has a specific meaning in ISO/IEC 13818-1, MPEG syntax). The AFD data is ...
SMPTE 292 is a digital video transmission line standard published by the Society of Motion Picture and Television Engineers (SMPTE). This technical standard is usually referred to as HD-SDI; it is part of a family of standards that define a serial digital interface based on a coaxial cable, intended to be used for transport of uncompressed digital video and audio in a television studio ...
The various serial digital interface standards all use (one or more) coaxial cables with BNC connectors, with a nominal impedance of 75 ohms. This is the same type of cable used in analog composite video setups, which potentially makes for easier "drop in" equipment upgrades (though may be necessary for long runs at the higher bitrates for older oxidising or lower grade of cable to replaced ...
An integrated receiver/decoder (IRD) is an electronic device used to pick up a radio-frequency signal and convert digital information transmitted in it. Consumer IRDs [ edit ]
A Transport Stream, and thereby ASI when over coax, can carry one or multiple SD, HD or audio programs that are already compressed, as opposed to an uncompressed SD-SDI (270 Mbit/s) or HD-SDI (1.485 Gbit/s). An ASI signal can be at varying transmission speeds and is completely dependent on the user's engineering requirements.
The key SPI parameters are: the maximum supported frequency for the serial interface, command-to-command latency, and the maximum length for SPI commands. It is possible to find SPI adapters on the market today that support up to 100 MHz serial interfaces, with virtually unlimited access length.
Note: Information in the chart has been superseded by the information in File:United States Frequency Allocations Chart 2016 - The Radio Spectrum.pdf, which was downloaded from the US Department of Commerce web site and archived at archive.org.
For telecommunications, a frequency grid is a table of all the central frequencies (and corresponding wavelengths) of channels allowed in a communications system.. The most common frequency grid used for fiber-optic communication is that used for channel spacing in Dense Wavelength Division Multiplexing (DWDM) at wavelengths around 1550 nm and defined by ITU-T G.694.1. [1]