Search results
Results from the WOW.Com Content Network
(In the obsolete composite versions of SDI, the ANC start sequence is a single word, 0x3FC). Three words immediately follow the start sequence in the header. The first word after the start sequence is the Data Identifier or DID , followed by either a ' Secondary Data Identifier ( SDID ) or a Data Block Number ( DBN ), followed by a Data Count ...
SMPTE 292 is a digital video transmission line standard published by the Society of Motion Picture and Television Engineers (SMPTE). This technical standard is usually referred to as HD-SDI; it is part of a family of standards that define a serial digital interface based on a coaxial cable, intended to be used for transport of uncompressed digital video and audio in a television studio ...
SMPTE has also adopted AFD for baseband SDI carriage as standard SMPTE 2016-1-2007, "Format for Active Format Description and Bar Data". Active Format Description is occasionally incorrectly referred to as "Active Format Descriptor". There is no "descriptor" (descriptor has a specific meaning in ISO/IEC 13818-1, MPEG syntax). The AFD data is ...
The various serial digital interface standards all use (one or more) coaxial cables with BNC connectors, with a nominal impedance of 75 ohms. This is the same type of cable used in analog composite video setups, which potentially makes for easier "drop in" equipment upgrades (though may be necessary for long runs at the higher bitrates for older oxidising or lower grade of cable to replaced ...
SMPTE 259M is a standard published by SMPTE which "describes a 10-bit serial digital interface operating at 143/270/360 Mb/s." [1]The goal of SMPTE 259M is to define a serial digital interface (based on a coaxial cable), called SDI or SD-SDI.
SDI-12 (Serial Digital Interface at 1200 baud) is an asynchronous serial communications protocol for intelligent sensors that monitor environment data. These instruments are typically low-power (12 volts), are used at remote locations, and usually communicate with a data logger or other data acquisition device.
An integrated receiver/decoder (IRD) is an electronic device used to pick up a radio-frequency signal and convert digital information transmitted in it. Consumer IRDs [ edit ]
This image or file is a work of a United States Department of Commerce employee, taken or made as part of that person's official duties. As a work of the U.S. federal government , the image is in the public domain .