Search results
Results from the WOW.Com Content Network
This can be improved by twisting the yarn-over stitch - similar to a "make one" (below) or purling the increase through the back loop in the return row. Raised Increase – Lift the strand connecting two knitted stitches in the row below onto the left needle (effectively producing a yarn-over) and knit it, either normally or twisted. This ...
The yarn-over may also be dropped on the next row, producing a longer stretch of yarn between the stitches of the previous row. Conversely, the effect of a yarn-over can be obtained by picking up the yarn between stitches of the previous row; the difference is that the yarn then is shorter, and the flanking stitches of the previous row may be ...
When seen from above, the twist can be clockwise (right yarn over left) or counterclockwise (left yarn over right); these are denoted as right- and left-plaited stitches, respectively. Hand-knitters generally produce right-plaited stitches by knitting or purling through the back loops, i.e., passing the needle through the initial stitch in an ...
Brioche knitting is a family of knitting patterns involving tucked stitches, i.e., yarn overs that are knitted together with a slipped stitch from the previous row. Such stitches may also be made by knitting into the row below (equivalent to the slipped stitch) and dropping the stitch above (equivalent to the yarn over).
Make a slip-knot in yarn and put it on the crochet hook or right-hand needle. Wrap the yarn from the back of the left-hand needle and over to the front, over the crochet hook or right needle, pass the slip-knot loop over the wrap, leaving the new loop on the crochet hook or right needle.
Unlike other types of yarn balls, a skein allows you to access both ends of the yarn. [34] The yarn end in the inside of the skein is called a center pull. [34] One major complaint of center pull bullet skeins is that the inside yarn end is not easily found, and often is pulled out of the skein in a jumble of tangled yarn called "yarn barf".
The technique is to wrap the yarn around all of the spool's pegs, twice. The lower loop of yarn is then lifted over the upper loop and off the peg, thereby creating stitches. The yarn is then wrapped around the entire loom, creating a new upper yarn on each peg. This process is repeated until the project is complete.
Diagram showing S and Z twist. There are two common ways to ply a balanced yarn: regular and chain plying. Both methods involve the manipulation of "singles"—unplied strands on their own—into multiple-ply yarns by applying twist in the opposite direction than how the single was spun. For example, if in spinning the single the wheel was spinning clockwise (called a "Z" twist, as on any ...