Search results
Results from the WOW.Com Content Network
5-inch (13 cm) flex suction hose with Storz fittings, mounted on an engine. Flexible suction hose (Flex suction or suction hose), not to be confused with hard suction hose in U.S., is a specific type of fire hose used in drafting operations, when a fire engine uses a vacuum to draw water from a portable water tank, pool, or other static water source.
For example, if the static compression ratio is 10:1, and the dynamic compression ratio is 7.5:1, a useful value for cylinder pressure would be 7.5 1.3 × atmospheric pressure, or 13.7 bar (relative to atmospheric pressure). The two corrections for dynamic compression ratio affect cylinder pressure in opposite directions, but not in equal strength.
In naturally aspirated engines powered by octane, maximum power is frequently reached at AFRs ranging from 12.5 to 13.3:1 or λ of 0.850 to 0.901. [citation needed] The air-fuel ratio of 12:1 is considered as the maximum output ratio, whereas the air-fuel ratio of 16:1 is considered as the maximum fuel economy ratio. [citation needed]
The LE2 is the direct-injection 1.4 L turbocharged variant of the SGE, with a 74 mm × 81.3 mm (2.91 in × 3.20 in) bore and stroke for a total capacity of 1,399 cc (1.4 L). Compression ratio is 10.0:1 and the engine can run on regular grade gasoline. The LE2 is also paired with a start-stop system in some vehicles.
The high compression ratio in the auxiliary combustion chamber causes the auto-ignition of the homogeneous lean air-fuel mixture therein (no spark plug required); the burnt gas bursts - through some "transfer ports", just before the TDC - into the main combustion chamber triggering its auto-ignition. The engine needs not be structurally stronger.
A stratified charge can allow for slightly higher compression ratios without "knock," and leaner air/fuel ratio than in conventional internal combustion engines. Conventionally, a four-stroke (petrol or gasoline) Otto cycle engine is fueled by drawing a mixture of air and fuel into the combustion chamber during the intake stroke.
It has the same displacement as the FA24F turbocharged engine with an identical 94×86 mm bore and stroke, but the compression level is increased to 12.5:1. [ 16 ] [ 17 ] Fitting the existing FA24F, with its bottom-mounted turbo, to the second generation Subaru BRZ/Toyota 86 would have required raising the price and overall center of gravity ...
The Toyota GR engine family is a gasoline, open-deck, piston V6 engine series. The GR series has a 60° die-cast aluminium block and aluminium DOHC cylinder heads.This engine series also features 4 valves per cylinder, forged steel connecting rods and crankshaft, one-piece cast camshafts, a timing chain, [1] and a cast aluminium lower intake manifold.