Search results
Results from the WOW.Com Content Network
The method is often done in four steps, [3] but it can be reduced to three: Step 1. Write the KCL equations of the circuit. At each node of an electric circuit, write the currents coming into and out of the node. Take care, however, in the MNA method, the current of the independent voltage sources is taken from the "plus" to the "minus" (see ...
In digital signal processing (DSP), parallel processing is a technique duplicating function units to operate different tasks (signals) simultaneously. [1] Accordingly, we can perform the same processing for different signals on the corresponding duplicated function units.
Parareal is a parallel algorithm from numerical analysis and used for the solution of initial value problems. [1] It was introduced in 2001 by Lions, Maday and Turinici.Since then, it has become one of the most widely studied parallel-in-time integration methods.
A bridge-parallel amplifier topology is a hierarchical combination of the bridged and paralleled amplifier topologies, with at least four single-ended channels needed to produce one bridge-parallel channel. The two topologies complement each other in that the bridging allows for higher voltage output and the paralleling provides the current ...
Due to the inherent difficulties in full automatic parallelization, several easier approaches exist to get a parallel program in higher quality. One of these is to allow programmers to add "hints" to their programs to guide compiler parallelization, such as HPF for distributed memory systems and OpenMP or OpenHMPP for shared memory systems.
A programmer that writes implicitly parallel code does not need to worry about task division or process communication, focusing instead on the problem that his or her program is intended to solve. Implicit parallelism generally facilitates the design of parallel programs and therefore results in a substantial improvement of programmer productivity.
IF amplifiers in heterodyne receivers apply gain in a frequency band between the input radio frequency and output audio frequency or video frequency, often following one stage of RF amplifier. This allows most of the gain in the form of a fixed-frequency amplifier, simplifying tuning. Compare to its predecessor, the tuned RF receiver.
The steps in deriving the gain using the asymptotic gain formula are outlined below for two negative feedback amplifiers. The single transistor example shows how the method works in principle for a transconductance amplifier, while the second two-transistor example shows the approach to more complex cases using a current amplifier.