Ads
related to: suction specific speed chart for tires
Search results
Results from the WOW.Com Content Network
Specific speed N s, is used to characterize turbomachinery speed. [1] Common commercial and industrial practices use dimensioned versions which are of equal utility. Specific speed is most commonly used in pump applications to define the suction specific speed —a quasi non-dimensional number that categorizes pump impellers as to their type and proportions.
Prior to 1964, tires were all made to a 90% aspect ratio. Tire size was specified as the tire width in inches and the diameter in inches – for example, 6.50-15. [29] From 1965 to the early 1970s, tires were made to an 80% aspect ratio. Tire size was again specified by width in inches and diameter in inches.
These represent the tire's resistance to the generation of heat at speed. Tires graded A effectively dissipate heat up to a maximum speed that is greater than 115 mph. B rates at a maximum between 100 mph and 115 mph. C rates at a maximum of between 85 mph to 100 mph. Tires that cannot grade up to C or higher cannot be sold in the US. [9]
The standard test speed for tire uniformity machines is 60 r/min of a standard load wheel that approximates 5 miles per hour. High speed uniformity machines are used in research and development environments that reach 250 km/h and higher. High speed uniformity machines have also been introduced for production testing.
Clincher tires can be mounted on straight-side or crochet-type rims. Crochet-type rims are not the same as hooked-bead rims. Such tires are designated with their nominal section width and their nominal rim diameter, separated by a hyphen (-). Both are measured in millimeters. A typical example of a tire marking according to ISO 5775-1 is:
is the specific speed; Cordier diagram can be used to determine specific speed and impeller tip diameter . Accordingly solidity ratio and hub-tip ratio (range 0.3-0.7) can be adjusted. Solidity ratio generally falls in the range of 0.4-1.1
Tire load sensitivity describes the behaviour of tires under load. Conventional pneumatic tires do not behave as classical friction theory would suggest. The load sensitivity of most real tires in their typical operating range is such that the coefficient of friction decreases as the vertical load, Fz, increases.
Air pressure in an automobile tire relative to atmosphere (gauge pressure) [citation needed] +210 to +900 kPa +30 to +130 psi Air pressure in a bicycle tire relative to atmosphere (gauge pressure) [57] 300 kPa 50 psi Water pressure of a garden hose [58] 300 to 700 kPa 50–100 psi Typical water pressure of a municipal water supply in the US [59]
Ads
related to: suction specific speed chart for tires