enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Orders of magnitude (power) - Wikipedia

   en.wikipedia.org/wiki/Orders_of_magnitude_(power)

   tech: the power consumption of a typical Light-emitting diode (LED) light bulb 8 tech: human-powered equipment using a hand crank. [14] 10 1: deca-(daW) 1.4 × 10 1: tech: the power consumption of a typical household compact fluorescent light bulb: 2–4 × 10 1: biomed: approximate power consumption of the human brain [15] 3–4 × 10 1

3. LED lamp - Wikipedia

   en.wikipedia.org/wiki/LED_lamp

   A 230-volt LED filament lamp, with an E27 base. The filaments are visible as the eight yellow vertical lines. An assortment of LED lamps commercially available in 2010: floodlight fixtures (left), reading light (center), household lamps (center right and bottom), and low-power accent light (right) applications An 80W Chips on board (COB) LED module from an industrial light luminaire, thermally ...

4. LED circuit - Wikipedia

   en.wikipedia.org/wiki/LED_circuit

   In 1969, Hewlett-Packard introduced the HP Model 5082-7000 Numeric Indicator, an early LED display and the first LED device to use integrated circuit technology. Its development was led by Howard C. Borden and Gerald P. Pighini at HP Associates and HP Labs , who had engaged in research and development (R&D) on practical LEDs between 1962 and ...

5. Multifaceted reflector - Wikipedia

   en.wikipedia.org/wiki/Multifaceted_reflector

   These lamps use a bi-pin connector for power: 12-volt MR11 bulbs usually use a GU4 base, and 12-volt MR16 bulbs usually use a GU5.3 base. The common 12-volt MR16 lamps, therefore, require a ferromagnetic or electronic transformer —sometimes misnamed as a ballast —to convert the 120- or 230-volt mains voltage to the extra-low voltage ...

6. Thermal management of high-power LEDs - Wikipedia

   en.wikipedia.org/wiki/Thermal_management_of_high...

   For heat transfer between LED sources over 15 Watt and LED coolers, it is recommended to use a high thermal conductive interface material (TIM) which will create a thermal resistance over the interface lower than 0.2 K/W. Currently, the most common solution is to use a phase-change material, which is applied in the form of a solid pad at room ...

7. Luminous efficacy - Wikipedia

   en.wikipedia.org/wiki/Luminous_efficacy

   It is the ratio of luminous flux to power, measured in lumens per watt in the International System of Units (SI). Depending on context, the power can be either the radiant flux of the source's output, or it can be the total power (electric power, chemical energy, or others) consumed by the source.