Search results
Results from the WOW.Com Content Network
An illustration of several key components in a typical four-stroke engine. For a four-stroke engine, key parts of the engine include the crankshaft (purple), connecting rod (orange), one or more camshafts (red and blue), and valves. For a two-stroke engine, there may simply be an exhaust outlet and fuel inlet instead of a valve system.
This is the case on many large aircraft such as the 747, C-17, KC-10, etc. If you are on an aircraft and you hear the engines increasing in power after landing, it is usually because the thrust reversers are deployed. The engines are not actually spinning in reverse, as the term may lead you to believe.
In an HCCI engine, however, the homogeneous mixture of fuel and air is compressed and combustion begins whenever sufficient pressure and temperature are reached. This means that no well-defined combustion initiator provides direct control. Engines must be designed so that ignition conditions occur at the desired timing.
The first flight with one of these engines took place on 22 February 2007, using a Boeing 747-100, fitted with one GEnx engine in the number 2 (inboard left hand side) position. By fall 2019, General Electric was offering the GEnx-2B, developed for the 747-8, for the revised 767-XF variant based on the 767-400ER, but needed enough volume to ...
This type of compressor is used in gas turbine engines, for supercharging reciprocating engines and for industrial processes, where it is known as a dynamic compressor. A map is created from compressor rig test results or predicted by a special computer program. Alternatively the map of a similar compressor can be suitably scaled.
ISO 8178 is a collection of steady state test cycles used for defining emission standards for non-road engines in the European Union, United States, Japan and other countries. Test cycle ISO 8178 C1 is also referred to as "Non-Road Steady Cycle" and used extensively. The Non-road Transient Cycle is supplementing it in some modern emission ...
An engine test stand is a facility used to develop, characterize and test engines. The facility, often offered as a product to automotive OEMs , allows engine operation in different operating regimes and offers measurement of several physical variables associated with the engine operation.
The first test engine consisted of only the core module (named "Kabini", a major tributary and often cited starting point of the Kaveri river), while the third engine was the first example fitted with variable stator vanes on the first three compressor stages.