Search results
Results from the WOW.Com Content Network
A typical ETC system consists of three major components: (i) an accelerator pedal module (ideally with two or more independent sensors), (ii) a throttle valve that can be opened and closed by an electric motor (sometimes referred to as an electric or electronic throttle body (ETB)), and (iii) a powertrain or engine control module (PCM or ECM). [4]
The AMC "cruise command" unit was actuated through a push-button on the dashboard once the car's desired speed was reached. The throttle position was automatically adjusted by a vacuum control that opened and closed the throttle based on input from the speedometer cable rather than through an adjustable control on the dashboard.
Early cars had a hand lever to control the throttle, either directly, or by controlling an engine speed governor which in turn controlled both the throttle and timing. [6] In 1900 the Wilson-Pilcher car was introduced in Britain which had a hand controlled speed governor, and a foot throttle which could override the action of the governor.
The predecessor of modern electronic traction control systems can be found in high-torque, high-power rear-wheel-drive cars as a limited slip differential.A limited-slip differential is a purely mechanical system that transfers a relatively small amount of power to the non-slipping wheel, while still allowing some wheel spin to occur.
The Cadillac Eldorado is a luxury car manufactured and marketed by Cadillac from 1952 until 2002 over twelve generations. The Eldorado was at or near the top of the Cadillac line. The original 1953 Eldorado convertible and the Eldorado Brougham models of 1957–1960 had distinct bodyshells [ 1 ] and were the most expensive models that Cadillac ...
A man in his 40s ate a carnivore diet that resulted in extremely high cholesterol levels, so much so that cholesterol came out of his palms, elbows and the soles of his feet, according to a recent ...
Cadillac Model 30 1908 tourer Rear view of 1908 tourer. The Cadillac Model Thirty was an American automobile introduced in December 1909 by the Cadillac Division of General Motors, and sold through 1911. It was the company's only model for those years and was based on the 1907 Model G. The 1912 Model 1912, 1913 Model 1913, and 1914 Model 1914 ...
A hill-holder is a motor vehicle device that holds the brake until the clutch is at the friction point, making it easier for a stationary vehicle to start uphill. By holding the brake in position while the vehicle is put into gear, it prevents rollback.