Search results
Results from the WOW.Com Content Network
A network and wildcard mask combination of 1.1.1.1 0.0.0.0 would match an interface configured exactly with 1.1.1.1 only, and nothing else. Wildcard masks are used in situations where subnet masks may not apply. For example, when two affected hosts fall in different subnets, the use of a wildcard mask will group them together.
An IP address is part of a CIDR block and is said to match the CIDR prefix if the initial n bits of the address and the CIDR prefix are the same. An IPv4 address is 32 bits so an n -bit CIDR prefix leaves 32 − n bits unmatched, meaning that 2 32− n IPv4 addresses match a given n -bit CIDR prefix.
In the above example, the subnet mask consists of 26 bits, making it 255.255.255.192, leaving 6 bits for the host identifier. This allows for 62 host combinations (2 6 −2). In general, the number of available hosts on a subnet is 2 h −2, where h is the number of bits used for the host portion of the address.
The default route in Internet Protocol Version 4 (IPv4) is designated as the zero address, 0.0.0.0 / 0 in CIDR notation. [2] Similarly, in IPv6, the default route is specified by :: / 0. The subnet mask is specified as / 0, which effectively specifies all networks and is the shortest match possible. A route lookup that does not match any other ...
RFC 1918 name IP address range Number of addresses Largest CIDR block (subnet mask) Host ID size Mask bits Classful description [Note 1]; 24-bit block: 10.0.0.0 – 10.255.255.255: 16 777 216
Used for loopback addresses to the local host [1] 169.254.0.0/16 169.254.0.0–169.254.255.255 65 536: Subnet Used for link-local addresses [5] between two hosts on a single link when no IP address is otherwise specified, such as would have normally been retrieved from a DHCP server 172.16.0.0/12 172.16.0.0–172.31.255.255 1 048 576: Private ...
Route table showing internet BGP routes . In computer networking, a routing table, or routing information base (RIB), is a data table stored in a router or a network host that lists the routes to particular network destinations, and in some cases, metrics (distances) associated with those routes.
Internet Protocol version 6 does not implement this method of broadcast, and therefore does not define broadcast addresses. Instead, IPv6 uses multicast addressing to the all-hosts multicast group. No IPv6 protocols are defined to use the all-hosts address, though; instead, they send and receive on particular link-local multicast addresses.