Search results
Results from the WOW.Com Content Network
Direct TPMS (dTPMS) directly measures tire pressure using hardware sensors. In each wheel, most often on the inside of the valve, there is a battery-driven pressure sensor which transfers pressure information to a central control unit which reports it to the vehicle's onboard computer.
direct TPM sensor fitted in valve system, manufacturer VDO. In most current designs of direct TPMS, a small electronic assembly which is rugged enough to be mounted inside a tire, measures the pressure using a microelectromechanical system (MEMS) [1] pressure sensor and then transmits this and other information to one or more vehicle receivers. [1]
The predecessor of modern electronic traction control systems can be found in high-torque, high-power rear-wheel-drive cars as a limited slip differential.A limited-slip differential is a purely mechanical system that transfers a relatively small amount of power to the non-slipping wheel, while still allowing some wheel spin to occur.
There are four main components of ABS: wheel speed sensors, valves, a pump, and a controller. ABS speed sensors Speed sensors (Encoders) A speed sensor is used to determine the acceleration or deceleration of the wheel. These sensors use a magnet and a Hall effect sensor, or a toothed wheel and an electromagnetic coil to generate a signal. The ...
In the tire factory, the tire and wheel are mounted on a balancing machine test wheel, the assembly is rotated at 100 RPM (10 to 15 mph with recent high sensitivity sensors) or higher, 300 RPM (55 to 60 mph with typical low sensitivity sensors), and forces of unbalance are measured by sensors. [1]
This correction enables a larger maximum permissible air gap at the speed sensor. On a module m = 1 target wheel these new sensors can tolerate an air gap of 1.4 mm, which is wider than that for conventional speed sensors on module m = 2 target wheels. On a module m = 2 target wheel the new speed sensors can tolerate gap of as much as 2.2 mm.
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
The electromagnetic parking sensor (EPS) was re-invented and patented in 1992 by Mauro Del Signore. [2] Electromagnetic sensors rely on the vehicle moving slowly and smoothly towards the object to be avoided. Once an obstacle is detected, the sensor continues to signal the presence of the obstacle even if the vehicle momentarily stops.