Search results
Results from the WOW.Com Content Network
Population equivalent (PE) or unit per capita loading, or equivalent person (EP), is a parameter for characterizing industrial wastewaters.It essentially compares the polluting potential of an industry (in terms of biodegradable organic matter) with a population (or certain number of people), which would produce the same polluting load.
A total maximum daily load (TMDL) is a regulatory term in the U.S. Clean Water Act, describing a plan for restoring impaired waters that identifies the maximum amount of a pollutant that a body of water can receive while still meeting water quality standards.
BOD test bottles at the laboratory of a wastewater treatment plant. Biochemical oxygen demand (also known as BOD or biological oxygen demand) is an analytical parameter representing the amount of dissolved oxygen (DO) consumed by aerobic bacteria growing on the organic material present in a water sample at a specific temperature over a specific time period.
The units MLSS is primarily measured in milligram per litre (mg/L), but for activated sludge its mostly measured in gram per litre [g/L] which is equal to kilogram per cubic metre [kg/m3]. Mixed liquor is a combination of raw or unsettled wastewater or pre-settled wastewater and activated sludge within an aeration tank.
The wastewater itself is a carrier of energy and a theoretical calculation, based on the characteristic of the sewage, shows that the composition of the embedded energy is 80% thermal energy and 20% chemical energy. [29] The thermal energy can be recovered as heat while the chemical energy is recovered as biogas.
TSS of a water or wastewater sample is determined by pouring a carefully measured volume of water (typically one litre; but less if the particulate density is high, or as much as two or three litres for very clean water) through a pre-weighed filter of a specified pore size, then weighing the filter again after the drying process that removes all water on the filter.
The widely used UASB reactor, for example, is a suspended-growth high-rate digester, with its biomass clumped into granules that will settle relatively easily and with typical loading rates in the range 5-10 kgCOD/m 3 /d. [2] Most common types of anaerobic digestion are liquid, plug-flow and solid-state type digesters. [6]
This is a double layer high load system, with 2 settler layers. The upflow rates are high below the first settler layer, and low below the second settler layer - this keeps both the 'adult' and 'baby' grains in the system, which pays off in greater net growth of granular sludge. Typical loading rates for an ECSB; 15 - 35 kg COD / m3 / day.