enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. List of valves - Wikipedia

   en.wikipedia.org/wiki/List_of_valves

   The sheet has a solid end and a flow-through end; sliding it from one position to the other opens or stops the flow. Also called sliding blind valve; Outflow valve: regulates flow and pressure, part of cabin pressurization; Pilot valve: regulates flow or pressure to other valves; Petcock, a small shut-off valve

3. Plug valve - Wikipedia

   en.wikipedia.org/wiki/Plug_valve

   The simplest and most common general type of plug valve is a 2-port valve [1] [2] with two positions: open to allow flow, and shut (closed) to stop flow. Ports are openings in the valve body through which fluid can enter or leave. The plug in this kind of valve has one passageway going through it.

4. Tap (valve) - Wikipedia

   en.wikipedia.org/wiki/Tap_(valve)

   A single temperature tap is commonly found in a commercial or public restroom where the temperature of the water will be controlled by a separate temperature regulating valve that mixes hot and cold water. The regulating valve may be under the handwashing sink or in a separate mechanical room or service closet.

5. Water key - Wikipedia

   en.wikipedia.org/wiki/Water_key

   Another design is called an Amado water key after its inventor. It consists of a short hollow cylinder mounted transversely on the slide. The cylinder has a button on one side that operates an enclosed stopper valve held shut with a spring, and a hole on the bottom side to drain the water. [2]

6. Valve - Wikipedia

   en.wikipedia.org/wiki/Valve

   The shut off butterfly valve for a Francis turbine at Gordon Power Station, Tasmania Ball valve. The "seat" is the interior surface of the body which contacts the disc to form a leak-tight seal. In discs that move linearly or swing on a hinge or trunnion, the disc comes into contact with the seat only when the valve is shut.

7. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   Non-return or check valves allow the free flow of a fluid in one direction but prevent its flow in a reverse direction. They are often seen in drainage or sewage systems but may also be used in pressurized systems. Valves are available in several types, based on design and purpose: Gate, plug, or ball valves – Isolation; Globe valve ...