enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Cable tester - Wikipedia

   en.wikipedia.org/wiki/Cable_tester

   A cable tester is an electronic device used to verify the electrical connections in a signal cable or other wired assembly. Basic cable testers are continuity testers that verify the existence of a conductive path between ends of the cable, and verify the correct wiring of connectors on the cable. More advanced cable testers can measure the ...

3. Copper cable certification - Wikipedia

   en.wikipedia.org/wiki/Copper_cable_certification

   The delay skew test is used to find the difference in propagation delay between the fastest and slowest set of wire pairs. An ideal skew is between 25 and 50 nanoseconds over a 100-meter cable. The lower this skew the better; less than 25 ns is excellent, but 45 to 50 ns is marginal.

4. Attenuation-to-crosstalk ratio - Wikipedia

   en.wikipedia.org/wiki/Attenuation-to-crosstalk_ratio

   Attenuation-to-crosstalk ratio (ACR) is a parameter that is measured when testing a communication link, which represents the overall performance of the cable. [1] AcR is a mathematical formula that calculates the ratio of attenuation to near-end crosstalk for each combination of cable pairs. [ 2 ]

5. Time-domain reflectometer - Wikipedia

   en.wikipedia.org/wiki/Time-domain_reflectometer

   These traces were produced by a commercial TDR using a step waveform with a 25 ps risetime, a sampling head with a 35 ps risetime, and an 18-inch (0.46 m) SMA cable. [9] The far end of the SMA cable was left open or connected to different adapters. It takes about 3 ns for the pulse to travel down the cable, reflect, and reach the sampling head.

6. Cable fault location - Wikipedia

   en.wikipedia.org/wiki/Cable_fault_location

   Murray loop test employs the principle of wheatstone bridge for locating the fault. To perform this test, it is necessary to have a sound cable running alongside the faulty cable. One end of the faulted cable is connected through a pair of resistors to the voltage source. Also a null detector is connected. The other end of the cable is shorted.

7. Continuity tester - Wikipedia

   en.wikipedia.org/wiki/Continuity_tester

   Entry-level cable testers are essentially continuity testers. A continuity tester is an item of electrical test equipment used to determine if an electrical path can be established between two points; [1] that is if an electrical circuit can be made. The circuit under test is completely de-energized prior to connecting the apparatus. [1]