Search results
Results from the WOW.Com Content Network
The standard defines how to signal the H-sync and V-sync pins in a standard SVGA monitor to trigger the monitor's power saving capabilities. DPMS defines four modes: normal, standby, suspended and off. When in the "off" state, some power may still be drawn in order to power indicator lights. The standard is:
A second display or second displays is a common term describing the multi-monitor setup with just one additional monitor attached. Today it is particularly common to have one workstation with two monitors connected where the second monitor is referred to as the second display. Many tablets will serve as a second display connected to a laptop. [22]
Preferred timing mode specified in descriptor block 1. For EDID 1.3+ the preferred timing mode is always in the first Detailed Timing Descriptor. In that case, this bit specifies whether the preferred timing mode includes native pixel format and refresh rate. Bit 0: Continuous timings with GTF or CVT: 25–34 Chromaticity coordinates.
It may be used to power a remote control receiver so that when infrared or radio-frequency signals are sent by a remote control device, the equipment can respond, typically by changing from standby to fully on mode. Standby power may be used to power a display, operate a clock, etc., without switching the equipment to full power.
The computer is running and the CPU executes instructions. "Away mode" is a subset of S0, where monitor is off but background tasks are running. G1 Sleeping S0ix Modern Standby, [34] or "Low Power S0 Idle". Partial processor SoC sleep. [35] [36] Sub states include S0i1, S0i2 and S0i3. Known to ARM and x86 devices. S1
Power management is a feature of some electrical appliances, especially copiers, computers, computer CPUs, computer GPUs and computer peripherals such as monitors and printers, that turns off the power or switches the system to a low-power state when inactive.
Sleep mode (or suspend to RAM) is a low power mode for electronic devices such as computers, televisions, and remote controlled devices. These modes save significantly on electrical consumption compared to leaving a device fully on and, upon resume, allow the user to avoid having to reissue instructions or to wait for a machine to boot .
The F17 signal from the scaler turned the AGC power and the AGC back on at 1.28 second intervals. In this mode, the AGC performed essential functions, checked the standby allowed switch, and, if still enabled, turned off the power and went back to sleep until the next F17 signal.