Search results
Results from the WOW.Com Content Network
Size comparison between a rat trap (above) and a mousetrap (below). Similar ranges of traps are sized for to trap other animal species; for example, rat traps are larger than mousetraps, and squirrel traps are larger still. A squirrel trap is a metal box-shaped device that is designed to catch squirrels and other similarly sized animals.
The hole for the set is usually made in front of some type of object which is where medium-sized animals such as coyotes, fox or bobcats would use for themselves to store food. This object could be a tuft of taller grass, a stone, a stump, or some other natural object. The dirt from the hole is sifted over the trap and a lure applied around the ...
Pit for hunting wolves, near Hohenwart, Bavaria, Germany. Trapping pits are deep pits dug into the ground, or built from stone, in order to trap animals. European rock drawings and cave paintings reveal that bear, moose and wolf were hunted since the Stone Age using trapping pits.
It is a simple spike, made out of wood or bamboo, which is sharpened, heated, and usually set in a hole. Punji sticks are usually deployed in substantial numbers. [ 1 ] The Oxford English Dictionary (third edition, 2007) lists less frequent, earlier spellings for "punji stake (or stick)": panja, panjee, panjie, panji , and punge .
For premium support please call: 800-290-4726 more ways to reach us
Nominal (thread) sizes range from 0.1875 to 0.375 in (4.763 to 9.525 mm) and lengths from 1.25 to 5 in (32 to 127 mm). Typically an installer uses a hammer drill to make a pilot hole for each concrete screw and a powered impact driver to drive the screw. The drill hole should be 1/2" longer than the depth penetration of the screw.
A self-tapping screw is a screw that can tap its own hole as it is driven into the material. More narrowly, self-tapping is used only to describe a specific type of thread-cutting screw intended to produce a thread in relatively soft material or sheet materials, excluding wood screws .
Example (inch, coarse): For size 7 ⁄ 16 (this is the diameter of the intended screw in fraction form)-14 (this is the number of threads per inch; 14 is considered coarse), 0.437 in × 0.85 = 0.371 in. Therefore, a size 7 ⁄ 16 screw (7 ⁄ 16 ≈ 0.437) with 14 threads per inch (coarse) needs a tap drill with a diameter of about 0.371 inches.