Search results
Results from the WOW.Com Content Network
When a system on a chip (SoC) enters suspend to RAM mode, in many cases, the processor is completely off while the RAM is put in self refresh mode. At resume, the boot ROM is executed again and many boot ROMs are able to detect that the SoC was in suspend to RAM and can resume by jumping directly to the kernel which then takes care of powering on again the peripherals which were off and ...
The STM32 F4-series is the first group of STM32 microcontrollers based on the ARM Cortex-M4F core. The F4-series is also the first STM32 series to have DSP and floating-point instructions. The F4 is pin-to-pin compatible with the STM32 F2-series and adds higher clock speed, 64 KB CCM static RAM, full-duplex I²S, improved real-time clock, and ...
STM32 Nucleo [260] STMicroelectronics: STM32 Family Arduino connectors and ST Morpho headers SunDuinoPIC [102] PIC18F2550 or PIC18F4550: Microchip PIC Arduino hardware compatible board. Based PINGUINO Project. USB HID Bootloader. Breeze [261] [262] PIC: Breeze boards are prototyping platforms for 28-pin PIC microcontrollers.
The C166 family [1] is a 16-bit microcontroller architecture from Infineon (formerly the semiconductor division of Siemens) in cooperation with STMicroelectronics.It was first released in 1990 and is a controller for measurement and control tasks.
Note: The column MBR (Master Boot Record) refers to whether or not the boot loader can be stored in the first sector of a mass storage device. The column VBR (Volume Boot Record) refers to the ability of the boot loader to be stored in the first sector of any partition on a mass storage device.
In-circuit emulation (ICE) is the use of a hardware device or in-circuit emulator used to debug the software of an embedded system.It operates by using a processor with the additional ability to support debugging operations, as well as to carry out the main function of the system.
All LPC microcontrollers have a ROM'ed bootloader that supports loading a binary image into its flash memory using one or more peripherals (varies by family). Since all LPC bootloaders support loading from the UART peripheral and most boards connect a UART to RS-232 or a USB -to- UART adapter IC, thus it's a universal method to program the LPC ...
Instead, some special registers in some microcontroller architectures require special instructions to modify them. For example, the program counter is not directly writeable in many microcontroller architectures. Instead, the programmer uses instructions such as return from subroutine, jump, or branch to modify the program counter.