Search results
Results from the WOW.Com Content Network
A level control valve or altitude control valve is a type of valve that automatically responds to changes in the height of a liquid in some storage system. A common example is the set of ballcocks in a flush toilet, where each stage of the flush cycle is actuated by the emptying or filling of the tank. Another example is in reservoirs and other ...
The visible water surface in a toilet is the top of the trap's water seal. Each fixture drain, with exceptions, must be vented so that negative air pressure in the drain cannot siphon the trap dry, to prevent positive air pressure in the sewer from forcing gases past the water seal, and to prevent explosive sewer gas buildup.
A sewer pipe is normally at neutral air pressure compared to the surrounding atmosphere.When a column of waste water flows through a pipe, it compresses air ahead of it in the system, creating a positive pressure that must be released so it does not push back on the waste stream and downstream traps, slow drainage, and induce potential clogs.
As the tank water level drops, the float descends and actuates the fill valve. Water is fed to the tank to replenish its supply, and a smaller flow is directed into the overflow tube to refill the bowl. Once the flapper valve closes, the water flow from the fill valve continues until the tank level again reaches the fill line.
A toilet seat is a hinged unit consisting of a round or oval open seat, and usually a lid, which is bolted onto the bowl of a toilet used in a sitting position (as opposed to a squat toilet). The seat can be either for a flush toilet or a dry toilet .
Terrain cartography or relief mapping is the depiction of the shape of the surface of the Earth on a map, using one or more of several techniques that have been developed. Terrain or relief is an essential aspect of physical geography , and as such its portrayal presents a central problem in cartographic design , and more recently geographic ...
Diaphragm valves (or membrane valves) consists of a valve body with two or more ports, a flexible diaphragm, and a "weir or saddle" or seat upon which the diaphragm closes the valve. The valve body may be constructed from plastic , metal or other materials depending on the intended use.
The company was founded by William Elvis Sloan in Chicago, Illinois in 1906 with the introduction of the Royal flushometer, a valve to release a measured amount of water to flush a urinal or toilet. Initial sales were very poor: only a single Royal model flushometer was sold in 1906, and two in 1907.