Search results
Results from the WOW.Com Content Network
In 1810, at Jena, Seebeck described the action of light on silver chloride sensitised paper (a technique used by Johann Ritter). [7] [8] He observed that the exposed chemical would sometimes take on an approximate, pale version of the color of the solar spectrum as projected from a prism to which it had been exposed, and also reported the action of light for a wavelengths beyond the violet end ...
The Seebeck and Peltier effects are different manifestations of the same physical process; textbooks may refer to this process as the Peltier–Seebeck effect (the separation derives from the independent discoveries by French physicist Jean Charles Athanase Peltier and Baltic German physicist Thomas Johann Seebeck). The Thomson effect is an ...
In 1821, Thomas Johann Seebeck discovered that a thermal gradient formed between two different conductors can produce electricity. [5] [6] At the heart of the thermoelectric effect is that a temperature gradient in a conducting material results in heat flow; this results in the diffusion of charge carriers. The flow of charge carriers between ...
Thomas Johann Seebeck (1780–1831) discovered the thermoelectric effect in 1821. The symmetrical Peltier effect (Jean Charles Athanse Peltier, 1785–1845) uses an electric current to produce temperature differences. In the middle part of the twentieth century the thermo-electric generator was often used in place of galvanic batteries. [2]
The Seebeck coefficient (also known as thermopower, [1] thermoelectric power, and thermoelectric sensitivity) of a material is a measure of the magnitude of an induced thermoelectric voltage in response to a temperature difference across that material, as induced by the Seebeck effect. [2] The SI unit of the Seebeck coefficient is volts per ...
The efficiency of a thermoelectric device for electricity generation is given by , defined as =.. The maximum efficiency of a thermoelectric device is typically described in terms of its device figure of merit where the maximum device efficiency is approximately given by [7] = + ¯ + ¯ +, where is the fixed temperature at the hot junction, is the fixed temperature at the surface being cooled ...
Thermoelectric cooling uses the Peltier effect to create a heat flux at the junction of two different types of materials. A Peltier cooler, heater, or thermoelectric heat pump is a solid-state active heat pump which transfers heat from one side of the device to the other, with consumption of electrical energy, depending on the direction of the current.
This effect leads to a decrease in the electron (or hole, as may be the case) mobility, which results in a decreased conductivity. However, as the magnitude of the Seebeck coefficient increases with phonon drag, it may be beneficial in a thermoelectric material for direct energy conversion applications. The magnitude of this effect is typically ...