enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Turnbuckle - Wikipedia

   en.wikipedia.org/wiki/Turnbuckle

   A turnbuckle, stretching screw or bottlescrew is a device for adjusting the tension or length of ropes, cables, tie rods, and other tensioning systems. It normally consists of two threaded eye bolts , one screwed into each end of a small metal frame, one with a conventional right-hand thread and the other with a left-hand thread.

3. Stainless steel - Wikipedia

   en.wikipedia.org/wiki/Stainless_steel

   Stainless steel, also known as inox, corrosion-resistant steel (CRES), and rustless steel, is an iron-based alloy containing a minimum level of chromium that is resistant to rusting and corrosion. Stainless steel's resistance to corrosion results from the 10.5%, or more, chromium content which forms a passive film that can protect the material ...

4. Rigging (material handling) - Wikipedia

   en.wikipedia.org/wiki/Rigging_(material_handling)

   Rigging is the equipment such as wire rope, turnbuckles, clevis, jacks used with cranes and other lifting equipment [1] in material handling and structure relocation. Rigging systems commonly include shackles, master links and slings, and lifting bags in underwater lifting.

5. Safety wire - Wikipedia

   en.wikipedia.org/wiki/Safety_wire

   A safety wire is used to ensure proper security for a fastener. The wire needed is long enough to reach from a fixed location to a hole in the removable fastener, such as a pin — a clevis fastener, sometimes a linchpin or hitch-pin through a clevis yoke for instance — and the wire pulled back upon itself, parallel to its other end, then twisted, a single end inserted through a fastener ...

6. List of electrical cable manufacturers - Wikipedia

   en.wikipedia.org/wiki/List_of_electrical_cable...

   Bambach Wires & Cables: 12,000 1.1 References This page was last edited on 26 August 2023, at 04:58 (UTC). Text is available under the Creative Commons ...

7. SMA connector - Wikipedia

   en.wikipedia.org/wiki/SMA_connector

   A 5 ⁄ 16 inch torque wrench is required for this, set to 3–5 in·lbf (0.3 to 0.6 N·m) for brass, and 7–10 in·lbf (0.8 to 1.1 N·m) for stainless steel connectors. Flats are sometimes also provided on the cable side of the connector assembly so that a second wrench can be used to prevent it from rotating and damaging the joint to the cable.