Search results
Results from the WOW.Com Content Network
Electroless nickel immersion gold (ENIG or ENi/IAu), also known as immersion gold (Au), chemical Ni/Au or soft gold, is a metal plating process used in the manufacture of printed circuit boards (PCBs), to avoid oxidation and improve the solderability of copper contacts and plated through-holes.
The thickness of gold plating on jewellery is noted in microns (or micro-meters). The microns of thickness determines how long the gold plating lasts with usage. The jewellery industry denotes different qualities of gold plating in the following terminology Gold flashed / Gold washed - gold layer thickness less than 0.5 micron
Electroless nickel plating, covered by a thin layer of gold, is used in the manufacture of printed circuit boards (PCBs), to avoid oxidation and improving the solderability of copper contacts and plated through holes and vias. The gold is typically applied by quick immersion in a solution containing gold salts.
The resist material protects the copper from dissolution into the etching solution. The etched board is then cleaned. A PCB design can be mass-reproduced in a way similar to the way photographs can be mass-duplicated from film negatives using a photographic printer. FR-4 glass epoxy is the most common insulating substrate.
PCB via current capacity chart showing 1 mil plating via current capacity & resistance versus diameter on a 1.6 mm PCB. In printed circuit board (PCB) design, a via consists of two pads in corresponding positions on different copper layers of the board, that are electrically connected by a hole through the board.
Through-hole (leaded) resistors. In electronics, through-hole technology (also spelled "thru-hole") is a manufacturing scheme in which leads on the components are inserted through holes drilled in printed circuit boards (PCB) and soldered to pads on the opposite side, either by manual assembly (hand placement) or by the use of automated insertion mount machines.
A coupon or test coupon is a printed circuit board (PCB) used to test the quality of a printed wiring board (PWB) fabrication process. Test coupons are fabricated on the same panel as the PWBs, typically at the edges. Coupons are then inspected to ensure proper layer alignment, electrical connectivity, and cross sectioned to inspect internal ...
Traditionally, conformal coating inspection has been done manually. An inspector usually examines each PCB under a high-intensity, long-wave ultraviolet lamp. Recent developments in conformal coating automated optical inspection (AOI) have begun to use Automated Inspection Systems, which can be camera- or scanner-based.