enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Garter spring - Wikipedia

   en.wikipedia.org/wiki/Garter_spring

   A garter spring inside a rubber seal. A garter spring is a coiled steel spring that is connected at each end to create a circular shape, and is used in oil seals, shaft seals, belt-driven motors, and electrical connectors. Compression garter springs exert outward radial forces, while extension garter springs exert inward radial forces.

3. Spring (device) - Wikipedia

   en.wikipedia.org/wiki/Spring_(device)

   Helical coil springs designed for tension A heavy-duty coil spring designed for compression and tension The English longbow – a simple but very powerful spring made of yew, measuring 2 m (6 ft 7 in) long, with a 470 N (105 lbf) draw weight, with each limb functionally a cantilever spring.

4. Coil spring - Wikipedia

   en.wikipedia.org/wiki/Coil_spring

   Coil springs are commonly used in vehicle suspension. These springs are compression springs and can differ greatly in strength and in size depending on application. A coil spring suspension can be stiff to soft depending on the vehicle it is used on. Coil spring can be either mounted with a shock absorber or mounted separately.

5. Arc spring - Wikipedia

   en.wikipedia.org/wiki/Arc_spring

   The arc spring (also known as - bow spring, curved spring, circular spring or "banana" spring) is a special form of coil spring which was originally developed for use in the dual-mass flywheel of internal combustion engine drive trains. The term "arc spring" is used to describe pre-curved or arc-shaped helical compression springs.

6. Belleville washer - Wikipedia

   en.wikipedia.org/wiki/Belleville_washer

   The load applied to the reduced-thickness spring to obtain a deflection equal to the 75% of the free height (of an unreduced spring) must be the same as for an unreduced spring. As the overall height is not reduced, springs with reduced thickness inevitably have an increased flank angle and a greater cone height than springs of the same nominal ...

7. Washer (hardware) - Wikipedia

   en.wikipedia.org/wiki/Washer_(hardware)

   Washers of standard metric sizes equivalent to BS4320 Form A are listed in the table below. Measurements in the table refer to the dimensions of the washers as described by the drawing. Specifications for standard metric flat washers were known as DIN 125 (withdrawn) and replaced with ISO 7089.