enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Socket wrench - Wikipedia

   en.wikipedia.org/wiki/Socket_wrench

   Pass-through sockets and ratchets are built for 1 ⁄ 4-inch, 3 ⁄ 8-inch and 1 ⁄ 2-inch sets in both SAE and metric sizes. By using a fine tooth ratchet and socket system that allow a pass-through ratchet to be used as a conventional ratchet handle with interchangeable 1 ⁄ 4-inch and 3 ⁄ 8-inch drives some ratchets can be used with ...

3. List of screw drives - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_drives

   Tamper-resistant versions with a pin in the recess are available. Metric sizes of the hex socket are defined by ISO 4762 (socket head cap screws), ISO 4026 (socket set screws with flat point), ISO 4027 (socket set screws with cone point), ISO 4028 (socket set screws with dog point), and ISO 4029 (socket set screws with cup point).

4. Hex key - Wikipedia

   en.wikipedia.org/wiki/Hex_key

   The idea of a hex socket screw drive was probably conceived as early as the 1860s to the 1890s, but such screws were probably not manufactured until around 1910. Rybczynski (2000) describes a flurry of patents for alternative drive types in the 1860s to the 1890s in the U.S., [2] which are confirmed to include internal-wrenching square and triangle types (that is, square and triangular sockets ...

5. Wrench size - Wikipedia

   en.wikipedia.org/wiki/Wrench_size

   Sizes that may interchange, depending on the precision needed, include 2 mm (close to 5 ⁄ 64 inch (1.98 mm)), 4 mm (close to 5 ⁄ 32 inch (3.97 mm)) and 8 mm (close to 5 ⁄ 16 inch (7.94 mm)). In reality, a wrench with a width across the flats of exactly 15 mm would fit too tightly to use on a bolt with a width across the flats of 15 mm.

6. IEC 60320 - Wikipedia

   en.wikipedia.org/wiki/IEC_60320

   A variety of different kinds of IEC 60320 plugs and sockets. IEC 60320 Appliance couplers for household and similar general purposes [1] is a set of standards from the International Electrotechnical Commission (IEC) specifying non-locking connectors for connecting power supply cords to electrical appliances of voltage not exceeding 250 V (a.c.) and rated current not exceeding 16 A. [1 ...

7. British Standard Whitworth - Wikipedia

   en.wikipedia.org/wiki/British_Standard_Whitworth

   British Standard Whitworth (BSW) is an imperial-unit-based screw thread standard, devised and specified by Joseph Whitworth in 1841 and later adopted as a British Standard. It was the world's first national screw thread standard, and is the basis for many other standards, such as BSF , BSP , BSCon , and BSCopper .