Search results
Results from the WOW.Com Content Network
A polycarbonate is an oxocarbon dianion consisting of a chain of carbonate units, where successive carbonyl groups are directly linked to each other by shared additional oxygen atoms. That is, they are the conjugate bases of polycarbonic acids , the conceptual anhydrides of carbonic acid , or polymers of carbon dioxide .
Polycarbonate is commonly used in eye protection, as well as in other projectile-resistant viewing and lighting applications that would normally indicate the use of glass, but require much higher impact-resistance. Polycarbonate lenses also protect the eye from UV light.
The Hildebrand solubility parameter is the square root of the cohesive energy density: =. The cohesive energy density is the amount of energy needed to completely remove a unit volume of molecules from their neighbours to infinite separation (an ideal gas).
Example Bjerrum plot: Change in carbonate system of seawater from ocean acidification.. A Bjerrum plot (named after Niels Bjerrum), sometimes also known as a Sillén diagram (after Lars Gunnar Sillén), or a Hägg diagram (after Gunnar Hägg) [1] is a graph of the concentrations of the different species of a polyprotic acid in a solution, as a function of pH, [2] when the solution is at ...
A typical example showing why Hildebrand parameters can be unhelpful is that two solvents, butanol and nitroethane, which have the same Hildebrand parameter, are each incapable of dissolving typical epoxy polymers. Yet a 50:50 mix gives a good solvency for epoxies.
Values of range from below 25 for very dense flint glasses, around 34 for polycarbonate plastics, up to 65 for common crown glasses, and 75 to 85 for some fluorite and phosphate crown glasses. Most of the human eye's wavelength sensitivity curve, shown here, is bracketed by the Abbe number reference wavelengths of 486.1 nm (blue) and 656.3 nm (red)
The Ostwald and de Waele equation can be written in a logarithmic form: log ( τ ) = log ( K ) + n log ( γ ˙ ) {\displaystyle \log(\tau )=\log(K)+n\log \left({\dot {\gamma }}\right)} The apparent viscosity is defined as η = τ γ ˙ {\displaystyle \eta ={\tau \over {\dot {\gamma }}}} , and this may be plugged into the Ostwald ...
For example, if narrow molar mass distribution standards are available for polystyrene, these can be used to construct a calibration curve (typically vs. retention volume ) in eg. toluene at 40 °C. This calibration can then be used to determine the "polystyrene equivalent" molecular weight of a polyethylene sample if the Mark-Houwink ...