Search results
Results from the WOW.Com Content Network
In electrical distribution, a fuse cutout or cut-out fuse (often referred to as a cutout) is a combination of a fuse and a switch, used in primary overhead feeder lines and taps to protect distribution transformers from current surges and overloads. An overcurrent caused by a fault in the transformer or customer circuit will cause the fuse to ...
A thermal fuse protecting the windings of a small motor Thermal fuse works like that: Melt gets too hot, strong spring sinks into melted substance, weak spring opens circuit. (Weak spring sits on ceramic insulator. A thermal fuse is a cutoff which uses a one-time fusible link.
In electrical engineering, IEC 60269 is a set of technical standards for low-voltage power fuses. [1] The standard is in four volumes, which describe general requirements, fuses for industrial and commercial applications, fuses for residential applications, and fuses to protect semiconductor devices.
An electrical fusible link is a type of electrical fuse that is constructed simply with a short piece of wire typically four American wire gauge (AWG) sizes smaller than the wire that is being protected. For example, an AWG 16 fusible link might be used to protect AWG 12 wiring.
A distribution board (also known as panelboard, circuit breaker panel, breaker panel, electric panel, fuse box or DB box) is a component of an electricity supply system that divides an electrical power feed into subsidiary circuits while providing a protective fuse or circuit breaker for each circuit in a common enclosure.
The Lucas 1/4" diameter glass tube fuse have a different length as compared to the standard US item. The Lucas 1/4" diameter glass tube fuse is 1 + 5 ⁄ 32 in (29 mm) long, while the US standard 1/4" glass tube fuse is 1 + 1 ⁄ 4 in (32 mm)] long. However, many Lucas fuse holders permit the longer US version to be installed easily.
Because standard safety fuse burns at around half a metre per minute, it is not practicable to provide delays of more than a few minutes in this way. It was also possible to connect a pencil detonator to so-called "instantaneous fuse" (not to be confused with detonating cord) which had an unusually fast burn rate of over 7 metres per second.
Once ignited, safety fuses will burn underwater, and have no external flame that might ignite methane or other fuels such as might be found in mines or other industrial environments. Safety fuses are manufactured with specified burn times per 30 cm, e.g. 60 seconds, which means that a length of fuse 30 cm long will take 60 seconds to burn.