Search results
Results from the WOW.Com Content Network
An Archimedes Screw Turbine (AST) hydroelectricity powerplant can be considered as a system with three major components: a reservoir, a weir, and the AST (which is connected to the system by a control gate and trash rack). At most real AST locations, the incoming flow must be divided between the AST and a parallel weir.
The GHT is a vertical-axis turbine which means the axis is positioned perpendicular to current flow, whereas traditional turbines are horizontal-axis turbines which means the axis is positioned parallel to the flow of the current. Fluid flows, such as wind, will naturally change direction, however they will still remain parallel to the ground.
Some hydropower systems such as water wheels can draw power from the flow of a body of water without necessarily changing its height. In this case, the available power is the kinetic energy of the flowing water. Over-shot water wheels can efficiently capture both types of energy. [7] The flow in a stream can vary widely from season to season.
It is an inward-flow reaction turbine that combines radial and axial flow concepts. Francis turbines are the most common water turbine in use today, and can achieve over 95% efficiency. [1] The process of arriving at the modern Francis runner design took from 1848 to approximately 1920. [1]
A Bonneville Dam Kaplan turbine after 61 years of service. The Kaplan turbine is a propeller-type water turbine which has adjustable blades. It was developed in 1913 by Austrian professor Viktor Kaplan, [1] who combined automatically adjusted propeller blades with automatically adjusted wicket gates to achieve efficiency over a wide range of flow and water level.
In this case the force on the wheel is the highest (due to the largest possible velocity change), but power delivered is zero, since there is no movement. For the case where the runner is moving at the speed of the stream, the velocity of the wheel is the highest, but power delivered is also zero, since there is no torque or force imparted on ...
Due to its excellent behaviour with partial loads, the cross-flow turbine is well-suited to unattended electricity production. Its simple construction makes it easier to maintain than other turbine types; only two bearings must be maintained, and there are only three rotating elements. The mechanical system is simple, so repairs can be ...
Load-following power plants can be hydroelectric power plants, diesel and gas engine power plants, combined cycle gas turbine power plants and steam turbine power plants that run on natural gas or heavy fuel oil, although heavy fuel oil plants make up a very small portion of the energy mix. A relatively efficient model of gas turbine that runs ...