enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Speed square - Wikipedia

   en.wikipedia.org/wiki/Speed_square

   Among its basic uses are marking common, hip, valley and hip, or valley jack rafters, laying out stair stringers, determining and marking angles, and making square cuts on boards. Common lines made using a speed square include perpendicular cut marks and Angles definition of an angle for roofs, stairways, and decks. The tool uses a 0° reference.

3. Dragon beam - Wikipedia

   en.wikipedia.org/wiki/Dragon_beam

   The dragon beam lies parallel to and below a hip rafter and carries the rafter. The dragon beam is carried by the wall on the outer end and by a horizontal piece between the two walls on the inside end. There are conflicting usages for this term in the U.K. and U.S.A. (see below). The most common usage seems to be combination dragon beam/cross tie.

4. Harbor Freight Tools - Wikipedia

   en.wikipedia.org/wiki/Harbor_Freight_Tools

   Harbor Freight Tools won a declassification of the class action; that is, the court found that all the individual situations were not similar enough to be judged as a single class, and that their claims would require an individual-by-individual inquiry, so the case could not be handled on a class basis.

5. Harbor Freight Tools new 16,000-square-foot store to open in ...

   www.aol.com/news/harbor-freight-tools-16-000...

   Harbor Freight Tools is opening a new 16,000-square-foot store in Fort Worth later this winter and will be hiring for 25 to 30 positions, the discount tool company said in a press release.. The ...

6. Rafter - Wikipedia

   en.wikipedia.org/wiki/Rafter

   Compass rafter: A rafter curved or bowed on the top (the top surface of a rafter is called its "back") or both the top and bottom surfaces. Curb rafter: The upper rafters in a curb (kerb, gambrel, Mansard roof) roof. Hip rafter (angle rafter): The rafter in the corners of a hip roof. The foot of a hip rafter lands on a dragon beam.

7. Steel square - Wikipedia

   en.wikipedia.org/wiki/Steel_square

   The hip or valley rafter also connects the ridge to the plate, but lies at a 45-degree angle to the common rafter. This number gives the length of the hip or valley rafter per seventeen units of run. Difference in lengths jacks. The jack rafters lie in the same plane as the common rafter but connect the top plate (the wall) or ridge board to ...