enow.com Web Search

  1. Ads

    related to: how to fix dripping spigot seal valve for water heater

Search results

  1. Results from the WOW.Com Content Network
  2. Tap (valve) - Wikipedia

    en.wikipedia.org/wiki/Tap_(valve)

    This is called a "globe valve" in engineering and, while it gives a leak-proof seal and good fine adjustment of flow, both the rubber washer and the valve seat are subject to wear (and for the seat, also corrosion) over time, so that eventually no tight seal is formed in the closed position, resulting in a leaking tap. The washer can be ...

  3. Leak - Wikipedia

    en.wikipedia.org/wiki/Leak

    For example, wearing out of faucet washers causes water to leak at the faucets. Cracks may result from either outright damage, or wearing out by stress such as fatigue failure or corrosion such as stress corrosion cracking. Wearing out of a surface between a disk and its seat in a valve could cause a leak between ports (valve inlets or outlets).

  4. Piping and plumbing fitting - Wikipedia

    en.wikipedia.org/wiki/Piping_and_plumbing_fitting

    A trap primer automatically injects water into a trap, maintaining a water seal to keep sewer gas out of buildings. It must be installed in an easily accessible place for adjustment, replacement, and repair. A trap primer, a specialized valve, is usually connected to a clean-water supply in addition to a DWV system. [20]

  5. Nipple (plumbing) - Wikipedia

    en.wikipedia.org/wiki/Nipple_(plumbing)

    Nipple. In plumbing and piping, a nipple is a fitting, consisting of a short piece of pipe, usually provided with a male pipe thread at each end, for connecting two other fittings.

  6. Water heating - Wikipedia

    en.wikipedia.org/wiki/Water_heating

    A tempering valve mixes enough cold water with the hot water from the heater to keep the outgoing water temperature fixed at a more moderate temperature, often set to 50 °C (122 °F). Without a tempering valve, reduction of the water heater's setpoint temperature is the most direct way to reduce scalding.

  7. Trap primer - Wikipedia

    en.wikipedia.org/wiki/Trap_primer

    A trap primer (or trap seal primer) is a plumbing device or valve that adds water to traps.The water seals in traps are needed to prevent sewer gases from entering buildings, but because this water is exposed to the air, it is subject to evaporation over time in infrequently used floor drains, leading to the release of sewer gas into the environment.

  1. Ads

    related to: how to fix dripping spigot seal valve for water heater