Search results
Results from the WOW.Com Content Network
Two-inch port tube installed in the top of a Polk S10 speaker cabinet as part of a DIY audio project. This port is flared. Unlike closed-box loudspeakers, which are nearly airtight, a bass reflex system has an opening called a port or vent cut into the cabinet, generally consisting of a pipe or duct (typically circular or rectangular cross section).
The effect is illustrated in Fig. 1, which shows a hard boundary at one end (the speaker) and the open-ended line vent at the other. The phase relationship between the bass driver and vent is in phase in the pass band until the frequency approaches the quarter wavelength, when the relationship reaches 90 degrees as shown.
Some speaker designs also use a spiral or elliptic spiral shaped duct, usually with one speaker element in the front or two speaker elements arranged one on each side of the cabinet. Depending upon the drive unit, and quantity and various physical properties of absorbent material, the amount of taper will be adjusted during the design process ...
MTX Audio loudspeaker enclosures (with rear panel reflex port tubes) which can mount 15-inch woofers, mid-range drivers and horn and/or compression tweeters. In this photo, only one driver is mounted. A cabinet with loudspeakers mounted in the holes. Number 1 is a mid-range driver. Number 2 is a high-range driver.
Moving iron speaker. The original loudspeaker design was the moving iron. Unlike the newer dynamic (moving coil) design, a moving-iron speaker uses a stationary coil to vibrate a magnetized piece of metal (called the iron, reed, or armature). The metal is either attached to the diaphragm or is the diaphragm itself.
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
For premium support please call: 800-290-4726 more ways to reach us
The braking effect is critical to speaker design, in that designers leverage it to ensure the speaker stops making sound quickly and that the coil is in position to reproduce the next sound. The electrical signal generated by the coil travels back along the speaker cable to the amplifier.