Search results
Results from the WOW.Com Content Network
In a chemical reaction, chemical equilibrium is the state in which both the reactants and products are present in concentrations which have no further tendency to change with time, so that there is no observable change in the properties of the system. [1] This state results when the forward reaction proceeds at the same rate as the reverse ...
Le Chatelier–Braun principle analyzes the qualitative behaviour of a thermodynamic system when a particular one of its externally controlled state variables, say , changes by an amount , the 'driving change', causing a change , the 'response of prime interest', in its conjugate state variable , all other externally controlled state variables remaining constant.
At equilibrium, the rate of transfer of CO 2 from the gas to the liquid phase is equal to the rate from liquid to gas. In this case, the equilibrium concentration of CO 2 in the liquid is given by Henry's law, which states that the solubility of a gas in a liquid is directly proportional to the partial pressure of that gas above the liquid. [1]
The Van 't Hoff equation relates the change in the equilibrium constant, K eq, of a chemical reaction to the change in temperature, T, given the standard enthalpy change, Δ r H ⊖, for the process. The subscript r {\displaystyle r} means "reaction" and the superscript ⊖ {\displaystyle \ominus } means "standard".
The change of the number of moles of A can be represented by the equation =, the change of B is = +, and the change of C is = +. [ 1 ] The change in the extent of reaction is then defined as [ 2 ] [ 3 ]
The free concentrations are calculated by solving the equations of mass-balance, and the concentrations of the complexes are calculated using the equilibrium constant definitions. A quantity corresponding to the observed quantity can then be calculated using physical principles such as the Nernst potential or Beer-Lambert law which relate the ...
The apparent dimension of this K value is concentration 1−p−q; this may be written as M (1−p−q) or mM (1−p−q), where the symbol M signifies a molar concentration (1M = 1 mol dm −3). The apparent dimension of a dissociation constant is the reciprocal of the apparent dimension of the corresponding association constant , and vice versa .
The typical McCabe–Thiele diagram in Figure 1 uses a q-line representing a partially vaporized feed. Example q-line slopes are presented in Figure 2. The number of steps between the operating lines and the equilibrium line represents the number of theoretical plates (or equilibrium stages) required for the distillation. For the binary ...