Ads
related to: best amplifier for vacuum tubes consumer reports- Multi-Room Amps
For Those Looking to Power Speakers
Across Multiple Zones of a Home
- 2-Channel Amps
Power a Single Set of Speakers or
Switch to Mono Mode to Drive a Sub
- Headphone Amps
Add a Headphone Amp to Get the Best
Possible Sound from Your Headphones
- Mono Amplifiers
Drive Your Sub and Get the Maximum
Bang for Your Buck with a Mono Amp
- Multi-Room Amps
ebay.com has been visited by 1M+ users in the past month
Search results
Results from the WOW.Com Content Network
A valve audio amplifier or vacuum tube audio amplifier is a valve amplifier used for sound reinforcement, sound recording and reproduction. Until the invention of solid state devices such as the transistor , all electronic amplification was produced by valve (tube) amplifiers.
6N3C power tube. A valve amplifier or tube amplifier is a type of electronic amplifier that uses vacuum tubes to increase the amplitude or power of a signal.Low to medium power valve amplifiers for frequencies below the microwaves were largely replaced by solid state amplifiers in the 1960s and 1970s.
A valve RF amplifier (UK and Aus.) or tube amplifier is a device for electrically amplifying the power of an electrical radio frequency signal. Low to medium power valve amplifiers for frequencies below the microwaves were largely replaced by solid state amplifiers during the 1960s and 1970s, initially for receivers and low power stages of ...
Tube sound (or valve sound) is the characteristic sound associated with a vacuum tube amplifier (valve amplifier in British English), a vacuum tube-based audio amplifier. [1] At first, the concept of tube sound did not exist, because practically all electronic amplification of audio signals was done with vacuum tubes and other comparable ...
The tube is popular in hi-fi vacuum tube audio as a low-noise line amplifier, driver (especially for tone stacks), and phase-inverter in vacuum tube push–pull amplifier circuits. It was widely used, in special-quality versions such as ECC82 and 5814A, in pre-semiconductor digital computer circuitry.
The biasing of a push–pull output stage can be adjusted (at the design stage, usually not in a finished amplifier) between class A (giving best open-loop linearity) through classes AB1 and AB2, to class B (giving greatest power and efficiency from a given power supply, output valves and output transformer).
Ads
related to: best amplifier for vacuum tubes consumer reportsebay.com has been visited by 1M+ users in the past month