Search results
Results from the WOW.Com Content Network
To establish a reference range, the Clinical and Laboratory Standards Institute (CLSI) recommends testing at least 120 patient samples. In contrast, for the verification of a reference range, it is recommended to use a total of 40 samples, 20 from healthy men and 20 from healthy women, and the results should be compared to the published reference range.
Verification is intended to check that a product, service, or system meets a set of design specifications. [6] [7] In the development phase, verification procedures involve performing special tests to model or simulate a portion, or the entirety, of a product, service, or system, then performing a review or analysis of the modeling results.
Clinical laboratories in the US that perform high complexity testing require a high complexity laboratory director (HCLD) that has earned doctoral degree in a chemical, physical, biological or clinical laboratory science from an accredited institution and be certified and continue to be certified by a board approved by HHS.
Validation or verification is generally needed when a health facility acquires a new device to perform medical tests. The main difference between the two is that validation is focused on ensuring that the device meets the needs and requirements of its intended users and the intended use environment, whereas verification is focused on ensuring ...
In practice, the term medical laboratory technician may apply to persons who are trained to operate equipment and perform tests, usually under the supervision of the certified medical technologist or laboratory scientist. Depending on the state where employment is granted, the job duties between MLSs and MLTs may or may not be similar.
Manufacturers delivering products to government bodies or in regulated industries such as medical device must typically meet more stringent requirements than international requirements. If there are special test requirements outside of the suppliers capability then test maybe subcontracted to a 3rd party accredited testing lab. [1]
ISO/IEC 17025 General requirements for the competence of testing and calibration laboratories is the main standard used by testing and calibration laboratories. In most countries, ISO/IEC 17025 is the standard for which most labs must hold accreditation in order to be deemed technically competent.
The EPA's Good Laboratory Practice Standards (GLPS) compliance monitoring program guarantees the accuracy and reliability of test data submitted to the Agency to support pesticide product registration under the Federal Insecticide, Fungicide and Rodenticide Act (FIFRA), section 5 of the Toxic Substances Control Act (TSCA), and in accordance ...