Search results
Results from the WOW.Com Content Network
The method for calculating the size of a flitch beam to be used in construction is straightforward, using the transformed-section method. The steel plate is treated as an equally stiff piece of wood, with its width modified by the ratio of their moduli of elasticity. This allows the deflection of the entire beam to be calculated as if it were ...
The typical thickness to width ratio of a plate structure is less than 0.1. [citation needed] A plate theory takes advantage of this disparity in length scale to reduce the full three-dimensional solid mechanics problem to a two-dimensional problem. The aim of plate theory is to calculate the deformation and stresses in a plate subjected to loads.
The board foot or board-foot is a unit of measurement for the volume of lumber in the United States and Canada. [1] It equals the volume of a board that is one foot (30.5 cm) in length, one foot in width, and one inch (2.54 cm) in thickness, or exactly 2.359 737 216 liters .
In most of the world, sheet metal thickness is consistently specified in millimeters. In the U.S., the thickness of sheet metal is commonly specified by a traditional, non-linear measure known as its gauge. The larger the gauge number, the thinner the metal. Commonly used steel sheet metal ranges from 30 gauge to about 7 gauge.
A plate is a structural element which is characterized by a three-dimensional solid whose thickness is very small when compared with other dimensions. [ 1 ] The effects of the loads that are expected to be applied on it only generate stresses whose resultants are, in practical terms, exclusively normal to the element's thickness.
In the paper and fabric industries, it is called grammage and is expressed in grams per square meter (g/m 2); for paper in particular, it may be expressed as pounds per ream of standard sizes ("basis ream"). A related area number density can be defined by replacing mass by number of particles or other countable quantity, with resulting units of ...
Gusset plates can be made into a variety of shapes and sizes and from a range of materials. Gusset plates are usually square or rectangular, but can be triangular or made into a customized shape to fit the joint. The shape of each plate is designed so that welding or bolts can be applied to different edges of the plate. [2]
A36 steel in plates, bars, and shapes with a thickness of less than 8 inches (203 millimeters) has a minimum yield strength of 36 ksi (250 MPa) and ultimate tensile strength of 58–80 ksi (400–550 MPa).