Search results
Results from the WOW.Com Content Network
An 802.11n-only network may be impractical for many users because they need to support legacy equipment that still is 802.11b/g only. In a mixed-mode system, an optimal solution would be to use a dual-radio access point and place the 802.11b/g traffic on the 2.4 GHz radio and the 802.11n traffic on the 5 GHz radio. [17]
Ethernet over USB is the use of a USB link as a part of an Ethernet network, resulting in an Ethernet connection over USB (instead of e.g. PCI or PCIe).. USB over Ethernet (also called USB over Network or USB over IP) is a system to share USB-based devices over Ethernet, Wi-Fi, or the Internet, allowing access to devices over a network.
A wireless network interface device with a USB interface and internal antenna A Bluetooth interface card. A wireless network interface controller (WNIC) is a network interface controller which connects to a wireless network, such as Wi-Fi, Bluetooth, or LTE (4G) or 5G rather than a wired network, such as an Ethernet network.
The network controller implements the electronic circuitry required to communicate using a specific physical layer and data link layer standard such as Ethernet or Wi-Fi. [a] This provides a base for a full network protocol stack, allowing communication among computers on the same local area network (LAN) and large-scale network communications through routable protocols, such as Internet ...
IEEE 802.11be, dubbed Extremely High Throughput (EHT), is a wireless networking standard in the IEEE 802.11 set of protocols [6] [7] which is designated Wi-Fi 7 by the Wi-Fi Alliance. [ 8 ] [ 9 ] [ 10 ] It has built upon 802.11ax , focusing on WLAN indoor and outdoor operation with stationary and pedestrian speeds in the 2.4, 5, and 6 GHz ...
IEEE 802.11ac-2013 or 802.11ac is a wireless networking standard in the IEEE 802.11 set of protocols (which is part of the Wi-Fi networking family), providing high-throughput wireless local area networks (WLANs) on the 5 GHz band. [d] The standard has been retroactively labelled as Wi-Fi 5 by Wi-Fi Alliance. [6] [7]
Some of Ralink's 802.11n RT2800 chipsets have been accepted into the Wi-Fi Alliance 802.11n draft 2.0 core technology testbed. They have also been selected in the Wi-Fi Protected Setup (WPS) and Wireless Multimedia Extensions Power Save (WMM-PS) testbeds. Ralink was a participant in the Wi-Fi Alliance and the IEEE 802.11 standards committees. [1]
802.11-1997 was the first wireless networking standard in the family, but 802.11b was the first widely accepted one, followed by 802.11a, 802.11g, 802.11n, 802.11ac, and 802.11ax. Other standards in the family (c–f, h, j) are service amendments that are used to extend the current scope of the existing standard, which amendments may also ...