Search results
Results from the WOW.Com Content Network
A pipe near the bottom of the blowoff tank maintains a water level below the blowdown entry point and allows cooler water remaining from earlier blowdown events to drain from the tank first. Two bottom blowdown valves are often used in series to minimize erosion. One valve serves as the sealing valve, and the other as the blowdown valve.
Mean time to repair (MTTR) is a basic measure of the maintainability of repairable items. It represents the average time required to repair a failed component or device. [ 1 ] Expressed mathematically, it is the total corrective maintenance time for failures divided by the total number of corrective maintenance actions for failures during a ...
MDT can be defined as mean time which the system is down after the failure. Usually, MDT is considered different from MTTR (Mean Time To Repair); in particular, MDT usually includes organizational and logistical factors (such as business days or waiting for components to arrive) while MTTR is usually understood as more narrow and more technical.
Heat traps are valves or loops of pipe on the cold water inlet and hot water outlet of water heaters. The heat traps allow cold water to flow into the water heater tank, but prevent unwanted natural convection and heated water to flow out of the tank. [1] [2] Newer water heaters have built-in heat traps.
Mean time to recovery (MTTR) [1] [2] [3] is the average time that a device will take to recover from any failure. Examples of such devices range from self-resetting fuses (where the MTTR would be very short, probably seconds), to whole systems which have to be repaired or replaced.
where MTTR is the mean time to repair. The MTTF of a system is the sum of MTTF S and MTTF D. To understand the relationship between MTTF S and MTTF D consider the case of a switch that turns a motor on or off. The switch has two failure modes: the switch can fail stuck closed or the switch can fail stuck open.
part of the water level gauge, which normally consists of a vertical glass tube connected top and bottom to the boiler backplate. The water level must be visible within the glass at all times. [3] Grooving erosion of a boiler's plates from the internal water space, particularly where there is a step inside the shell.
Domestically, water is traditionally heated in vessels known as water heaters, kettles, cauldrons, pots, or coppers. These metal vessels that heat a batch of water do not produce a continual supply of heated water at a preset temperature. Rarely, hot water occurs naturally, usually from natural hot springs. The temperature varies with the ...