Search results
Results from the WOW.Com Content Network
The capacitance between two parallel plates that results in one volt of potential difference when charged by one coulomb of electricity. [ 32 ] = 1 F = 1 C/V = 1 A 2 ⋅s 4 /(kg⋅m 2 )
The conversion of conductivity (in μS/cm) to the total dissolved solids (in mg/kg) depends on the chemical composition of the sample and can vary between 0.54 and 0.96. Typically, the conversion is done assuming that the solid is sodium chloride; 1 μS/cm is then equivalent to about 0.64 mg of NaCl per kg of water.
conversion combination output units SI: square kilometre: km2 km 2: US spelling: square kilometer: 1.0 km 2 (0.39 sq mi) km2 sqmi; square metre: m2 m 2: US spelling: square meter: 1.0 m 2 (11 sq ft) m2 sqft; square centimetre: cm2 cm 2: US spelling: square centimeter: 1.0 cm 2 (0.16 sq in) cm2 sqin; square millimetre: mm2 mm 2: US spelling ...
Unit type Unit code Unit name Area: a: are: m2: square metre Charge: coulomb: coulomb Energy: J: joule Force: N: newton Length: m: metre Magnetic field strength: T ...
For example, the CGS unit of force is the dyne, which is defined as 1 g⋅cm/s 2, so the SI unit of force, the newton (1 kg⋅m/s 2), is equal to 100 000 dynes. On the other hand, in measurements of electromagnetic phenomena (involving units of charge , electric and magnetic fields, voltage , and so on), converting between CGS and SI is less ...
The SI has special names for 22 of these coherent derived units (for example, hertz, the SI unit of measurement of frequency), but the rest merely reflect their derivation: for example, the square metre (m 2), the SI derived unit of area; and the kilogram per cubic metre (kg/m 3 or kg⋅m −3), the SI derived unit of density.
Conversion of units is the conversion of the unit of measurement in which a quantity is expressed, typically through a multiplicative conversion factor that changes the unit without changing the quantity. This is also often loosely taken to include replacement of a quantity with a corresponding quantity that describes the same physical property.
Volumetric flow rate is defined by the limit [3] = ˙ = =, that is, the flow of volume of fluid V through a surface per unit time t.. Since this is only the time derivative of volume, a scalar quantity, the volumetric flow rate is also a scalar quantity.