Search results
Results from the WOW.Com Content Network
A damp-proof course (DPC) [2] is a barrier through the structure designed to prevent moisture rising by capillary action such as through a phenomenon known as rising damp. Rising damp is the effect of water rising from the ground into property. [3] The damp proof course may be horizontal or vertical. [4]
A vapor barrier (or vapour barrier) is any material used for damp proofing, typically a plastic or foil sheet, that resists diffusion of moisture through the wall, floor, ceiling, or roof assemblies of buildings and of packaging to prevent interstitial condensation.
Damp proofing is another aspect of waterproofing. Masonry walls are built with a damp-proof course to prevent rising damp , and the concrete in foundations needs to be damp-proofed or waterproofed with a liquid coating, basement waterproofing membrane (even under the concrete slab floor where polyethylene sheeting is commonly used), or an ...
The Federal Emergency Management Agency (FEMA) recommends basement waterproofing with a water alarm and "battery-operated backup pump" as a preventive measure against the high cost of flooding. [2] Wall conduits (such as dimple boards or other membranes) are fastened to the foundation wall and extend over the new drainage to guide any moisture ...
The purpose of a Vertical Damp Proof Barrier is to prevent the ingress of damp and water into subterranean structures such as basements, cellars, tunnels and earth shielded buildings. (Also known as Earth sheltered buildings ).
Damp-proofing rods are available with BBA approval. The rods are placed into holes drilled in the mortar course and the active ingredients diffuse along the mortar line before curing to form a damp-proof course. [53] Damp-proofing rods are usually supplied in 180mm (7") lengths suitable for inserting into a 9-inch thick wall.
Replacing the roofing felt on a Scout hall in Wales. Bituminous waterproofing systems are designed to protect residential and commercial buildings.Bitumen (asphalt or coal-tar pitch) is a material made up of organic liquids that are highly sticky, viscous, and waterproof. [1]
The Mogden formula calculates cost as a combination (empirical coefficients) of volume, strength in terms of normal treatment oxidation demand and the suspended solids proportion. [1] Applicable to the whole works, it also approximates the cost for tested industrial waste water that may, if treatable, be lawfully sent to a regular sewage works.