Search results
Results from the WOW.Com Content Network
The voltage is constant only in the sense that at full power, the voltage in the system does not depend on the number of speakers driven (as long the amplifier's maximum power is not exceeded). [2] Constant-voltage speaker systems are also commonly referred to as 25- , 70- , 70.7- , 100 or 210-volt speaker systems ; distributed speaker systems ...
The term loudspeaker may refer to individual transducers (also known as drivers) or to complete speaker systems consisting of an enclosure and one or more drivers.. To adequately and accurately reproduce a wide range of frequencies with even coverage, most loudspeaker systems employ more than one driver, particularly for higher sound pressure level (SPL) or maximum accuracy.
Sixteen ohm drivers (or loudspeakers systems) would be connected to the 16-ohm tap, 8 ohm to the 8 ohm tap, etc. This is significant since the ratio between the loudspeaker impedance and the amplifier's impedance at a particular frequency provides damping (i.e., energy absorption) for the back EMF generated by a driver.
[citation needed] High-power in-car audio systems using 2-ohm speaker circuits require thicker wire than 4 to 8-ohm home audio applications. Most consumer applications use two conductor wire. A common rule of thumb is that the resistance of the speaker wire should not exceed 5 percent of the rated impedance of the system.
Passive radiators are used in Bluetooth speakers, home stereo speakers, subwoofer cabinets and car audio speaker systems, particularly in cases where there is not enough space for a port or vent system. While most studio monitor speakers are either ported bass reflex designs, or closed-back without a vent or passive radiator, Mackie's HR824 and ...
They use a network of passive electrical components (e.g., capacitors, inductors and resistors) to split up an amplified signal coming from one power amplifier so that it can be sent to two or more loudspeaker drivers (e.g., a woofer and a very low frequency subwoofer, or a woofer and a tweeter, or a woofer-midrange-tweeter combination).
For premium support please call: 800-290-4726 more ways to reach us
The electroacoustic mechanism most widely used in speakers to convert the electric current to sound waves is the dynamic or electrodynamic driver, invented in 1925 by Edward W. Kellogg and Chester W. Rice, which creates sound with a coil of wire called a voice coil suspended between the poles of a magnet.