Search results
Results from the WOW.Com Content Network
British Standard Pipe Parallel Thread Dimensions; British Standard Pipe Taper Thread Dimensions Archived 2017-09-27 at the Wayback Machine; BSP Thread Charts and Diagrams, showing dimensions of tubing and fittings; ISO 7-1:1994; ISO 7-2:2000; ISO 228-1:2000; ISO 228-2:1987; Parallel pipe threads G; Parallel pipe threads PF
Metric Screw Threads - MJ Profile: V Thread Form BS 84: Tables of BS Whitworth, BS Fine and BS Pipe Threads: V Thread Form (55°) 1 ⁄ 4 ″-20 BSW ISO 68-1:1998: ISO general purpose screw threads—Basic profile—Part 1: Metric screw threads: V Thread Form ISO 68-2:1998: ISO general-purpose screw threads—Basic profile—Part 2: Inch screw ...
Example (metric, coarse): For M7.0×1.0 (an intended screw with a diameter of 7.0 mm and a pitch of 1 mm between each thread, which is considered coarse), 7.0 mm × 0.85 = 5.95 mm. The drill sizes that are near this are 15 ⁄ 64 in (85%), 6.0 mm (85.7%), and 6.1 mm (87.1%); any of these will work well. Example (metric, fine): For M7.0×0.5, 7. ...
Below is the historical thread size table, not to be confused with G threads, which are actually in use as British Standard Pipe. For example a G½ (half inch) is 20.955mm in diameter. For example a G½ (half inch) is 20.955mm in diameter.
In other countries, a British Standard Pipe (BSP) thread is used, which is 3 ⁄ 4 inch (19 mm) and 14 TPI (male part outside diameter is 26.441 mm or 1.04 in). The GHT and BSP standards are not compatible, and attempting to connect a GHT hose to a BSP fitting, or vice versa, will damage the threads. The connector threads are not tapered, and ...
My own view is that DN is preferable because this refers to the pipe size, and any given pipe size can only be threaded to the same thread size, whereas mm is an exact mm dimension but one which has no direct relationship to the thread size, eg, 1/2" is 12.7mm not 15mm, and 3/4" is 19.1mm not 20mm, etc. —Preceding unsigned comment added by ...
A metric ISO screw thread is designated by the letter M followed by the value of the nominal diameter D (the maximum thread diameter) and the pitch P, both expressed in millimetres and separated by a dash or sometimes the multiplication sign, × (e.g. M8-1.25 or M8×1.25).
Imperial Metric fastening size conversion charts; International Thread Standards; Conversion chart Whitworth/BSF/AF and metric Archived 2 May 2010 at the Wayback Machine; Spanner Jaw Sizes Additional information and spanner jaw size table. Unified Screw Threads Series; ASME B1.1-2003 Unified Inch Screw Threads, (UN and UNR Thread Form)