Search results
Results from the WOW.Com Content Network
In the modern standard metric version, it is simply a size number, where listed diameter size is the major outer diameter of the external thread. For a taper thread, it is the diameter at the "gauge length" (plus/minus one thread pitch) from the small end of the thread.
Metric Screw Threads - MJ Profile: V Thread Form BS 84: Tables of BS Whitworth, BS Fine and BS Pipe Threads: V Thread Form (55°) 1 ⁄ 4 ″-20 BSW ISO 68-1:1998: ISO general purpose screw threads—Basic profile—Part 1: Metric screw threads: V Thread Form ISO 68-2:1998: ISO general-purpose screw threads—Basic profile—Part 2: Inch screw ...
Below is the historical thread size table, not to be confused with G threads, which are actually in use as British Standard Pipe. For example a G½ (half inch) is 20.955mm in diameter. For example a G½ (half inch) is 20.955mm in diameter.
In other countries, a British Standard Pipe (BSP) thread is used, which is 3 ⁄ 4 inch (19 mm) and 14 TPI (male part outside diameter is 26.441 mm or 1.04 in). The GHT and BSP standards are not compatible, and attempting to connect a GHT hose to a BSP fitting, or vice versa, will damage the threads. The connector threads are not tapered, and ...
A metric ISO screw thread is designated by the letter M followed by the value of the nominal diameter D (the maximum thread diameter) and the pitch P, both expressed in millimetres and separated by a dash or sometimes the multiplication sign, × (e.g. M8-1.25 or M8×1.25).
My own view is that DN is preferable because this refers to the pipe size, and any given pipe size can only be threaded to the same thread size, whereas mm is an exact mm dimension but one which has no direct relationship to the thread size, eg, 1/2" is 12.7mm not 15mm, and 3/4" is 19.1mm not 20mm, etc. —Preceding unsigned comment added by ...
The standard for Nominal Pipe Size (often abbreviated NPS, which should not be confused with the abbreviation NPS for the straight thread form standard) is loosely related to the inside diameter of Schedule 40 series of sizes. Because of the pipe wall thickness of Schedule pipe, the actual diameter of the NPT threads is larger than the Nominal ...
Example (metric, coarse): For M7.0×1.0 (an intended screw with a diameter of 7.0 mm and a pitch of 1 mm between each thread, which is considered coarse), 7.0 mm × 0.85 = 5.95 mm. The drill sizes that are near this are 15 ⁄ 64 in (85%), 6.0 mm (85.7%), and 6.1 mm (87.1%); any of these will work well. Example (metric, fine): For M7.0×0.5, 7. ...