Search results
Results from the WOW.Com Content Network
The SAE has a separate viscosity rating system for gear, axle, and manual transmission oils, SAE J306, which should not be confused with engine oil viscosity. The higher numbers of a gear oil (e.g., 75W-140) does not mean that it has higher viscosity than an engine oil 20W-50.
Both Rotella T4 15W-40 conventional and, Rotella T6 5W-40 and 15w-40 Synthetic both list the JASO MA/MA 2 standard; this information can be found on the bottle adjacent to the SAE/API rating stamp. JASO is an acronym that stands for Japanese Automotive Standards Organization. Note that the 10W-30 conventional oil does not list JASO-MA.
UTQG ratings on sidewall of Toyo Tires Proxes R39 tire UTQG ratings (top) and tire code (bottom) on sidewall of Continental ContiProContact tire. Uniform Tire Quality Grading, commonly abbreviated as UTQG, is a set of standards for passenger car tires that measures a tire's treadwear, temperature resistance and traction.
Rolling resistance is the main key factor in measuring the energy efficiency of a tyre and has direct influence on the fuel consumption of a vehicle. A set of tyres of the green class "A" compared to a "G" class can reduce fuel consumption by 9% [3] of a passenger car; even more for trucks.
Starting in 1972 tires were specified by load rating, using a letter code. In practice, a higher load rating tire was also a wider tire. In this system a tire had a letter, optionally followed by "R" for radial tires, followed by the aspect ratio, a dash and the diameter – C78-15 or CR78-15 for bias and radial, respectively. Each diameter of ...
The Society of Automotive Engineers (SAE) has established a numerical code system for grading motor oils according to their viscosity characteristics known as SAE J300. This standard is commonly used throughout the world, and standards organizations that do so include API [ 16 ] and ACEA . [ 17 ]
Tire uniformity refers to the dynamic mechanical properties of pneumatic tires as strictly defined by a set of measurement standards and test conditions accepted by global tire and car makers. These standards include the parameters of radial force variation , lateral force variation , conicity, ply steer, radial run-out , lateral run-out , and ...
A United States National Highway Traffic Safety Administration (NHTSA) study in 2009 found that if 2% of the replacement tires would reduce their rolling resistance by 5%, there would be 7.9 million gallons fuel and 76,000 metric tons of CO 2 saved annually. [citation needed] (SAE J1269 and SAE J2452) performed on new tires.