enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Water heating - Wikipedia

   en.wikipedia.org/wiki/Water_heating

   Under the pre-2015 standard, a 75 US gal (280 L; 62 imp gal) gas storage water heater with a nominal input of 22 kW (75,000 BTU/h) or less was able to have an energy factor as low as 53%, while under the 2015 standard, the minimum energy factor for a 75-US-gallon gas storage tank water heater is now 74%, which can only be achieved by using ...

3. Tankless water heating - Wikipedia

   en.wikipedia.org/wiki/Tankless_water_heating

   The defining characteristics of a "hybrid water heater" are: A combination of the water flow capacity of a tank, and efficiency of tankless; Built-in small storage water reservoir as part of heat exchanger (typically between 2 US gallons (7.6 L; 1.7 imp gal) to 20 gallons) Dual activation: flow sensing and thermostat control

4. Water heat recycling - Wikipedia

   en.wikipedia.org/wiki/Water_heat_recycling

   Installation of a double-walled copper-on-copper heat exchanger in a vertical section of the master drain line in a Canadian home (2007) Water heat recycling (also known as drain water heat recovery, waste water heat recovery, greywater heat recovery, [citation needed] or sometimes shower water heat recovery [citation needed]) is the use of a heat exchanger to recover energy and reuse heat ...

5. Storage water heater - Wikipedia

   en.wikipedia.org/wiki/Storage_water_heater

   Solar heat is clean and renewable. This is the most modern system. Increasingly, solar powered water heaters are being used. Their solar thermal collectors are installed outside dwellings, typically on the roof or walls or nearby, and the potable hot water storage tank is typically a pre-existing or new conventional water heater, or a water heater specifically designed for solar thermal.

6. Absorption refrigerator - Wikipedia

   en.wikipedia.org/wiki/Absorption_refrigerator

   Common absorption refrigerators use a refrigerant with a very low boiling point (less than −18 °C (0 °F)) just like compressor refrigerators.Compression refrigerators typically use an HCFC or HFC, while absorption refrigerators typically use ammonia or water and need at least a second fluid able to absorb the coolant, the absorbent, respectively water (for ammonia) or brine (for water).

7. Heat exchanger - Wikipedia

   en.wikipedia.org/wiki/Heat_exchanger

   Tubular heat exchanger Partial view into inlet plenum of shell and tube heat exchanger of a refrigerant based chiller for providing air-conditioning to a building. A heat exchanger is a system used to transfer heat between a source and a working fluid. Heat exchangers are used in both cooling and heating processes. [1]

8. Logarithmic mean temperature difference - Wikipedia

   en.wikipedia.org/wiki/Logarithmic_mean...

   Assume heat transfer [2] is occurring in a heat exchanger along an axis z, from generic coordinate A to B, between two fluids, identified as 1 and 2, whose temperatures along z are T 1 (z) and T 2 (z). The local exchanged heat flux at z is proportional to the temperature difference:

9. Central heating - Wikipedia

   en.wikipedia.org/wiki/Central_heating

   A boiler (or a heat exchanger for district heating) which heats water in the system; Pump to circulate the water; Radiators through which the heated water passes in order to release heat into rooms. The circulating water systems use a closed loop; the same water is heated and then reheated.