Search results
Results from the WOW.Com Content Network
A well-chosen speed for stone polishing causes the rocks within the barrel to slide past each other, with the abrasive grit between them. The result of this depends on the coarseness of the abrasive, and the duration of the tumble. Typically, a full tumble polish from rough rock to polish takes 3–5 weeks, and is done in a minimum of 3 steps.
Polishing is often used to enhance the appearance of an item, prevent contamination of instruments, remove oxidation, create a reflective surface, or prevent corrosion in pipes. In metallography and metallurgy, polishing is used to create a flat, defect-free surface for examination of a metal's microstructure under a microscope. Silicon-based ...
The term is based on the word "whet", which means to sharpen a blade, [3] [4] not on the word "wet". The verb nowadays to describe the process of using a sharpening stone for a knife is simply to sharpen, but the older term to whet is still sometimes used, though so rare in this sense that it is no longer mentioned in, for example, the Oxford Living Dictionaries.
However, an advantage of steel siding can be its dent-resistance, which is excellent for regions with severe storms—especially if the area is prone to hail. Embossed metal siding on 1890s building. The first architectural application of aluminium was the mounting of a small grounding cap on the Washington Monument in 1884.
A 2010 effort led by State Senator Gloria J. Romero, a Democrat from Los Angeles, sought to remove serpentine from its perch as the state's official stone. Organizations such as the Asbestos Disease Awareness Organization have supported the move as the olive green rock is a source of chrysotile , a form of asbestos that can cause mesothelioma ...
Superfinishing, also known as microfinishing [1] and short-stroke honing, is a metalworking process that improves surface finish and workpiece geometry. This is achieved by removing just the thin amorphous surface layer of fragmented or smeared metal left by the last process with an abrasive stone or tape; this layer is usually about 1 μm in magnitude.
The working edge of the hatchet or axe was sharpened by rubbing it against an abrasive stone, eventually leading to the creation of a shallow oval-shaped groove over time, [4] The grooves vary in length from 80 mm (3.1 in) up to 500 mm (20 in), and can be up to 200 mm (7.9 in) wide and 100 mm (3.9 in) deep. They are often found near water ...
Turned, ground, and polished (TGP) is a classification of finishing processes often used for metal shafting. Turning (on a lathe) creates straight round bars without the strain induced by cold drawing, while grinding and polishing improves the surface finish and roundness for high dimensional accuracy. [1]