Search results
Results from the WOW.Com Content Network
Bulbs of this type are commonly used in automotive lighting and in low-voltage lighting used in landscape lighting. The bulb may have dual filaments, acting as both a low-wattage tail light or parking light and a higher-wattage brake light or turn signal. In this case, one has its contacts near the center of the base, and the other toward the ...
The GU24 fitting is intended to maintain the energy efficiency of the light by preventing an occupant from using an incandescent bulb instead of a CFL. Adapters to use incandescent bulbs in a GU24 fitting are illegal in the State of California as they would be a fire hazard in fixtures designed for the lower heat output of a CFL bulb.
Backing is the rearmost section of the fishing line and typically used only to "pad up" the spool of the fishing reel, in order to prevent unwanted slippage between the mainline and the (usually metallic and well polished) spool surface, increase the effective radius of the spooled line and hence the retrieval speed (i.e. inches per turn), and ...
The suffix after the G indicates the pin spread; the G dates to the use of Glass for the original bulbs. GU usually also indicates that the lamp provides a mechanism for physical support by the luminaire: in some cases, each pin has a short section of larger diameter at the end (sometimes described as a "peg" rather than a "pin" [2]); the socket allows the bulb to lock into place by twisting ...
The uni knot is widely used for attaching hooks, rings and swivels to the end of the line [7] and it is also used for joining two fishing lines together. [8] The bend form of the uni knot (for joining two lines) is not a noose; rather it is akin to a multiple fisherman's knot with the two opposing knotted parts arranged in the manner of uni knots.
GY6.35 & GZ6.35 – same as G6.35 and only denote what lamp mount clip is needed to hold the actual light bulb in place; G8 – 8 mm (0.31496 in) pin spacing GU8 – same as G8 and only denotes what lamp mount clip is needed to hold the actual light bulb in place; GY8.6 – 8.6 mm (0.33858 in) pin spacing; G9 – 9 mm (0.35433 in) pin spacing
Fish are most attracted to true-green light colors, and LEDs do the best job of illuminating this color. A fishing light attractor is a fishing aid that uses lights attached to structures above water or suspended underwater to attract fish and members of their food chain. Fish are typically most attracted to true-green light colors.
The most commonly used A-series light bulb type is an A60 bulb [7] (or its inch-based equivalent, the A19 bulb [2] [4]), which is 60 mm (19 ⁄ 8 in or 2 + 3 ⁄ 8 in) wide at its widest point [3] and approximately 110 mm (4 + 3 ⁄ 8 in) in length. [8] Other sizes with a data sheet in IEC 60064 are A50, A55, A67, A68, A71, A75, and A80.