Search results
Results from the WOW.Com Content Network
The test often reveals problems that occurred during assembly, such as defective components, improper component placement, and insulator defects that may cause inadvertent shorting or grounding to chassis, in turn, compromising electrical circuit quality and product safety. [2]
The publication describes requirements, levels and test methods to achieve immunity compliance of an electronic product. The purpose is to create a reproducible ground for product compliance and the standard defines: ranges, levels, test equipment, setups, procedures, calibrations, generator waveforms and general uncertainties.
A chassis ground is a link between different metallic parts of a machine to ensure an electrical connection between them. [1] Examples include electronic instruments and motor vehicles. Usages
An insulation resistance test (IR test) measures the electrical resistance of insulation by applying a voltage between two locations, and measuring the resultant current flow. Proper safety precautions must be taken when doing this test, such as exclusion zones, making sure no wires are exposed, and personal protective equipment is worn.
The role “ground” may be ambiguous in systems that isolate different kinds of grounds (typical isolated grounds are analog signal ground, digital signal ground, AC power ground, DC power ground, and chassis ground). If different kinds of ground paths are in separate paths in a connector, the analysis should treat them as separate signals.
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
In electrical engineering, a dielectric withstand test (also pressure test, high potential test, hipot test, or insulation test) is an electrical safety test performed on a component or product to determine the effectiveness of its insulation. The test may be between mutually insulated sections of a part, or energized parts and ground.
In semiconductor testing, the device under test is a die on a wafer or the resulting packaged part. A connection system is used, connecting the part to automatic or manual test equipment. The test equipment then applies power to the part, supplies stimulus signals, then measures and evaluates the resulting outputs from the device.