Search results
Results from the WOW.Com Content Network
In the mid-1750s, the steam engine was applied to the water power-constrained iron, copper and lead industries for powering blast bellows. These industries were located near the mines, some of which were using steam engines for mine pumping. Steam engines were too powerful for leather bellows, so cast iron blowing cylinders were developed in 1768.
A steam engine is a heat engine that performs mechanical work using steam as its working fluid. The steam engine uses the force produced by steam pressure to push a piston back and forth inside a cylinder. This pushing force can be transformed by a connecting rod and crank into rotational force for work.
Developed for Charles Porter by Charles Richard, the steam engine indicator traces on paper the pressure in the cylinder throughout the cycle, which can be used to spot various problems and to optimize efficiency. [14] [19] Earlier versions of the steam engine indicator were in use by 1851, though relatively unknown. [20]
The company introduced high-pressure steam engines to the riverboat trade in the Mississippi watershed. The first high-pressure steam engine was invented in 1800 by Richard Trevithick. [44] The importance of raising steam under pressure (from a thermodynamic standpoint) is that it attains a higher temperature. Thus, any engine using high ...
The success to come with stationary steam engines was in no small part based on the experiences with the short-lived railway locomotive production: the locomotives had boilers rated for 50 pounds per square inch (3.4 bar), compared to the normal stationary engine boiler rating at that time of 5 or 10 psi (0.34 or 0.69 bar). [18]
The Sadler engine was a house-built table engine installed in a single-storey engine house with integral boiler; it replaced one of the horse-drives to the chain pumps. This engine was replaced in 1807 in the same house by another, more powerful, table engine made by Fenton, Murray and Wood of Leeds and, in turn, in 1830 by a Maudslay beam engine.
Soho Foundry main gate Blue plaque at the main gate Listed canal roving bridge at entrance to Soho Foundry Loop canal (now dry). Soho Foundry is a factory created in 1795 by Matthew Boulton and James Watt and their sons Matthew Robinson Boulton and James Watt Jr. [1] at Smethwick, West Midlands, England (grid reference), for the manufacture of steam engines.
In 1823 a Maudslay engine powered the Lightning, the first steam-powered vessel to be commissioned by the Royal Navy. In 1829 a side-lever engine of 400 h.p. completed for HMS Dee was the largest marine engine existing at that time. [4] The marine engine business was developed by Henry's third son, Joseph Maudslay (1801 - 1861).