Search results
Results from the WOW.Com Content Network
Chemical tests use reagents to indicate the presence of a specific chemical in an unknown solution. The reagents cause a unique reaction to occur based on the chemical it reacts with, allowing one to know what chemical is in the solution. An example is Heller's test where a test tube containing proteins has strong acids added to it.
Other interference may come from the buffer used when preparing the protein sample. A high concentration of buffer will cause an overestimated protein concentration due to depletion of free protons from the solution by conjugate base from the buffer. This will not be a problem if a low concentration of protein (subsequently the buffer) is used. [6]
the central organic synthesis reagent for hydroboration Dicyclohexylcarbodiimide: an organic compound; primary use is to couple amino acids during artificial peptide synthesis Diethyl azodicarboxylate: a valuable reagent but also quite dangerous and explodes upon heating Diethyl ether: organic compound; a common laboratory solvent Dihydropyran
Gravimetric analysis describes a set of methods used in analytical chemistry for the quantitative determination of an analyte (the ion being analyzed) based on its mass. The principle of this type of analysis is that once an ion's mass has been determined as a unique compound, that known measurement can then be used to determine the same analyte's mass in a mixture, as long as the relative ...
Sample preparation for mass spectrometry is used for the optimization of a sample for analysis in a mass spectrometer (MS). Each ionization method has certain factors that must be considered for that method to be successful, such as volume, concentration , sample phase, and composition of the analyte solution.
Reagent Chemicals [a] is a publication of the American Chemical Society (ACS) Committee on Analytical Reagents, [1] detailing standards of purity for over four hundred of the most widely used chemicals in laboratory analyses and chemical research. Chemicals that meet this standard may be sold as "ACS Reagent Grade" materials.
AQC is achieved through laboratory control of analytical performance. Initial control of the complete system can be achieved through specification of laboratory services, instrumentation, glassware, reagents, solvents, and gases. However, evaluation of daily performance must be documented to ensure continual production of valid data.
This reaction is rapid and stoichiometric, with the addition of one mole of thiol releasing one mole of TNB. The TNB 2− is quantified in a spectrophotometer by measuring the absorbance of visible light at 412 nm, using an extinction coefficient of 14,150 M −1 cm −1 for dilute buffer solutions, [4] [5] and a coefficient of 13,700 M −1 cm −1 for high salt concentrations, such as 6 M ...