Ads
related to: 4 1/2 inch pipe clamp wall mount anchorssupplyhouse.com has been visited by 100K+ users in the past month
zoro.com has been visited by 100K+ users in the past month
ebay.com has been visited by 1M+ users in the past month
Search results
Results from the WOW.Com Content Network
A pipe anchor is a rigid support that restricts movement in all three orthogonal directions and all three rotational directions, i.e. restricting al the 6 degrees of freedom This usually is a welded stanchion that is welded or bolted to steel or concrete. [2] In case of anchor which is bolted to concrete, a special type of bolt is required ...
A hold-down may also refer to clamping device used to anchor a pipe to a structural steel element or concrete floor or allow movement of the pipe in an axial direction. [1] At the bottom, the hold down is connected to the concrete foundation or structural slab by an embedded or epoxied anchor bolt. At the top, the hold down is connected to a ...
A deep channel 1 + 5 ⁄ 8 in × 2 + 7 ⁄ 16 in (41 mm × 62 mm) version is also manufactured. The material used to form the channel is typically sheet metal with a thickness of 1.5 mm or 2.5 mm (12 or 14 gauge; 0.1046 inch or 0.0747 inch, respectively). [2] Types of channel
A pipe clamp is a type of clamp often employed in piping, woodworking, and cabinet shops. Pipe clamps for woodwork or cabinet shops are usually composed of commercially manufactured clamp heads or "jaws" and a length of common threaded pipe. [1] [2] The capacity of the clamp is determined by the length of the pipe used.
The copper pipe penetration is firestopped with firestop mortar. Riser clamp for a standpipe through-penetration firestop inside a fire hose cabinet under construction. A riser clamp is a type of hardware used by mechanical building trades for pipe support in vertical runs of piping (risers) at each floor level. The devices are placed around ...
Screw clamps are normally used for hoses 1/2 inch diameter and up, with other clamps used for smaller hoses. The first patent for a worm-drive hose clamp was granted to Swedish inventor Knut Edwin Bergström [ se ] in 1896 [ 1 ] Bergström founded “Allmänna Brandredskapsaffären E. Bergström & Co.” in 1896 (ABA) to manufacture these worm ...
Ads
related to: 4 1/2 inch pipe clamp wall mount anchorssupplyhouse.com has been visited by 100K+ users in the past month
zoro.com has been visited by 100K+ users in the past month
ebay.com has been visited by 1M+ users in the past month