enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Speed square - Wikipedia

   en.wikipedia.org/wiki/Speed_square

   Among its basic uses are marking common, hip, valley and hip, or valley jack rafters, laying out stair stringers, determining and marking angles, and making square cuts on boards. Common lines made using a speed square include perpendicular cut marks and Angles definition of an angle for roofs, stairways, and decks. The tool uses a 0° reference.

3. List of roof shapes - Wikipedia

   en.wikipedia.org/wiki/List_of_roof_shapes

   Roof shapes include flat (or shed), gabled, hipped, arched, domed, and a wide variety of other configurations detailed below. [1]Roof angles are an integral component of roof shape, and vary from almost flat to steeply pitched.

4. Stairs - Wikipedia

   en.wikipedia.org/wiki/Stairs

   Stringer board, stringer, or sometimes just string: The structural member that supports the treads and risers in standard staircases. There are typically three stringers, one on either side and one in the center, with more added as necessary for wider spans. Side stringers are sometimes dadoed to receive risers and treads for increased support ...

5. Howe truss - Wikipedia

   en.wikipedia.org/wiki/Howe_truss

   In practice, most wood stringers are 16 inches (410 mm) in width due to limitations in milling. There are usually six stringers in a bridge. [18] Building the deck for a railroad bridge requires that a stringer lie directly beneath each rail, and that a stringer support each end of the railroad ties. Ties are usually 6 by 8 inches (150 by 200 ...

6. Rafter - Wikipedia

   en.wikipedia.org/wiki/Rafter

   A rafter is one of a series of sloped structural members such as steel beams that extend from the ridge or hip to the wall plate, downslope perimeter or eave, and that are designed to support the roof shingles, roof deck, roof covering and its associated loads. [2] A pair of rafters is called a couple.

7. Deck (bridge) - Wikipedia

   en.wikipedia.org/wiki/Deck_(bridge)

   A grid deck uses beams and diaphragms as the supporting structure. The supporting system of a grid deck is analyzed using a grillage analysis. A slab deck is one where the deck is analyzed as a plate. If the slab has a stiffness that is different in two directions (at right angles), then the deck is known and analyzed as an orthotropic deck.